Owner`s manual

TOYOTA Scion tC REFERENCE 400CF
Procedure
Issue A 08/01/11 Page | 9
2. Locate and remove the 10mm
ground bolt located in the
passenger side kick panel area.
(Fig. 7-8)
3. Install the harness ground
together with the factory ground.
Note: Make sure harness ground
terminal rest on top of the factory
ground.
4. Re-install the 10mm bolt and
tighten. (Fig. 7-9)
d. Run Driver side of Quick-Sync Harness.
1. Enter through the radio cavity and
run the harness towards the
accelerator pedal. (Fig. 7-10)
2. Separate the yellow power wires
from the main harness and lay on
the floor. (Fig. 7-11)