User manual

ConneXions II V8 (Euro), Multi Port Version

CONX8E/3 Issue 3

Preface

Installation

Installation must only be undertaken by an Approved contractor, who shall ensure that all work is carried

out in compliance with National Wiring Regulations. For mains powered equipment, a readily accessible

isolating fuse or switched socket must be located within 1 metre of the equipment.

No User Serviceable Parts

Alteration or modification to any part of this equipment, without the prior written consent of the

manufacturer, will invalidate all Approvals and Warranties attaching to the equipment. Further liability for

the operation of the equipment, under the applicable law, will pass to the user, who will absolve the

manufacturer of any further responsibility for it’s correct operation and use.

Liability

Scope does not accept liability for any damage or injury, howsoever caused as the result of misuse of this

equipment. It is the responsibility of the user to ensure that the equipment is operated in the manner for

which it was intended and that it is the correct item of equipment for the required task.

Warranty

This product is warranted as free from defects of workmanship and materials for a period of one year from

the original purchase date. During this time, if there is a defect or malfunction of this product, Scope will,

with proof of purchase, repair or replace at it’s discretion any defective parts, free of charge. This does not

include where the adjustments, parts and repair are necessary due to circumstances beyond the control of

Scope, including but not limited to fire or other casualty, accident, neglect, abuse, abnormal use or battery

leakage damage.

WARNING ! No User Serviceable Parts

Celui-ci ne contient aucune piece pouvant etre reparee par l’utilisateur

Caution ! Risk of electric shock, do not open.

Attention ! Risque de choc electrique, ne pas ouvrir.

Alteration or modification to any part of this equipment, without the prior written consent of the

manufacturer, will invalidate all manufacturer approvals and warranties. No adjustments can be

undertaken except by qualified and licensed persons as authorised by Scope.

WARNING ! SAFETY

This equipment must only be used with an Approved mains cord set rated at 5A minimum which is

fitted with an integral three prong, grounded mains plug and a moulded IEC320 style socket. The

cord set must only be plugged into a grounded, fused outlet rated 5A minimum.

This product complies with the essential requirements of the R&TTE Directive 1999/5/EC

Copies of the Declaration of Conformity covering this product can be obtained from Scope at:

Quantum House, Steamer Quay, Totnes TQ9 5AL United Kingdom.

Do not discard. At end of life this equipment must be sent to an authorised waste treatment centre. Contact

Scope at the above address for further details.