Instruction manual

CHANGING THE LITEPIPE

ON YOUR HiViz

SIGHT

(Ruger Mark III Hunter Models Only)

1. Point the muzzle in a safe direction.

2. Make sure that the magazine and the pistol are completely unloaded.

3. Place the thin tab on the HiViz

key between the LitePipe and the sight base.

This will compress the locking spring, allowing you to carefully pull the

LitePipe out of the supporting rings. Remove the key.

4. Slide the new LitePipe into the sight base. You will have to lightly press down

on the rounded end as it enters the far supported ring to compress the

locking spring.

INSTRUCTIONS FOR ATTACHING

THE SCOPE BASE

(Target Model Only)

1. Remove the filler screws from the top of the receiver.

2. Degrease the screw holes in the receiver.

3. Degrease the scope base screws.

4. After the degreased areas are dry, place a drop of red LOCTITE

adhesive/sealant or equivalent to the scope base screws.

5. Set the scope base on the receiver with the side notch aligned with the

ejection port of the receiver.

6. Install the scope base screws and tighten.

7. Set the assembled pistol aside overnight to allow the adhesive to set up.