User manual
23
WARNING! The anti-freezing cap should only be disassembled if there is reason to suspect that the func-
tionality or mounting of the anti-freezing unit is incorrect. If this is the case, see Section 12.3.5.
It is also very important to make sure that the anti-freezing unit is not exposed to water or dirt during
disassembly and assembly. Always repeat the visual inspection described in Section 4.1 before diving.
4.2 MOUNTING AN MKIII REGULATOR UNIT AND CYLINDER
PACK
• Mount the components in the following manner:
1. Place the cylinder pack on a at surface with the
cylinder valve facing you. Unscrew the safety
plug from the threaded inow. Make sure that
the O-ring is not still in the opening.
2
. Unscrew the yellow protective sleeve from the
regulator unit's high pressure coupling. Check
the O-ring. Connect the regulator unit between
the cylinders and the carrying handle so that the
anti-freezing cover is facing the cylinders.
3
. Screw the knob coupling carefully into the cylin-
der valve and only tighten by hand. Arrange the
hoses as illustrated in the gure below.