User manual

SCPUHF Paging Transmitter System
SCPUHF Issue 2
13
Other Antennas
The range and performance of this equipment can be improved by the addition of more efficient
antennas*. These can be installed either inside or outside the building and are connected to the
transmitter with 50 OHM coaxial cable.
Glass mount antenna (UHFGM): for installation on the inside of a suitable window. This can boost
range, especially if it is required in one direction from the building.
The centre fed half wave di-pole, measuring approximately 12 inches from tip to tip, will provide
excellent all round local signalling. This can be mounted either inside or outside a building. Two
versions are available:
1) a light duty antenna suitable for sheltered environments/internal installation (LUHFDP).
2) a heavy duty stainless unit with optional mounting hardware for more arduous applications
(UHFDP).
The 6dB end fed colinear (UHF6DB): for external application. When elevated, this will boost overall
range at a slight loss to some local signals.
Pre-terminated coaxial feeder cables are available for 5, 10 or 15 metre requirements.
Note ! High frequencies can equate to high power losses. Always use quality cable. RG58 is only
acceptable on cable runs of up to 5 metres. We recommend RG213, or equivalent, on greater
lengths. If in doubt consult our Technical Department.
*subject to license conditions. Specifically, mounting height and Effective Radiated Power (ERP).
Service Information
Pagers returned with flat, incorrectly installed or leaking batteries will be charged for!
In the event that a pager requires service, return it directly to Scope in the pre-addressed service bag
supplied with your system by registered post. Ensure that you carefully fill out the service form
provided. Failure to complete this form in full will result in inevitable delays!
If you experience a problem with your equipment you must first telephone our service hotline on
[phone], where we may request that you undertake a few simple checks. If a problem still
remains, we will arrange collection of your system by overnight carrier at our expense. Upon receipt,
we will endeavour to service or replace the system within 24 working hours and return the same by
overnight carrier.
We suggest that you retain the packaging for your control equipment. Incorrectly packed goods
returned for service are the responsibility of the customer. If we deem that new packaging is required
before we can return the unit, a charge will be made.
Record your system details here for quick reference:-
Date supplied____/____/____ Serial Number of the Transmitter ___________________
Transmitter frequency ___________________MHz Transmitter Type approval SERILINK
Number of pagers supplied with the system _______
System base ID number__________ Transmitter baud rate ______________
For information on individual pager types, refer to the appropriate pager manual