User manual

SCPUHF Paging Transmitter System
SCPUHF Issue 2
2
PREFACE
Important Installation Information
It is the purchasers’ responsibility to determine the suitability of this equipment and its derivatives for
any given application, Scope cannot give specific advice in this manual, as each use will require
independent evaluation.
Scope has, wherever possible, employed extra safeguards to monitor the system’s performance.
Certain system installations, operational requirements or budgets may, however, limit the
effectiveness of these safeguards. Again, the suitability of the system for any given application must
therefore be decided by the installer and their customer, relative to the application and risk.
Good working practice dictates that a suitable system installation log must be generated, together
with a record of the dates when the system has been manually checked, (with the aid of signal
strength meters etc.) enabling the system performance to be compared with the original installation
data.
Scope has no control of the use and application of the frequencies issued by OFCOM. Some
equipment that is licensed may have greater protection than other equipment which is operated on a
WT Act License Exempt basis.
The supply of this equipment is governed by our standard terms and conditions of sale, which can be
found on the reverse of all order acknowledgements*, proforma invoices*, delivery notes, price lists
and invoices. Alternatively, these can be provided on request.
* Faxed proforma invoices and quotations refer to “conditions available upon request”.
Important Safety Information
Scope products are designed to operate safely when installed and used according to general safety
practices. The following requirements should be observed at all times.
Do NOT subject this equipment to:
Mechanical shock
Excessive humidity or moisture
Extremes of temperature
Corrosive liquids
This equipment is designed for indoor use, unless expressly stated otherwise, and must not be used
in classified Hazardous Areas, including areas containing explosive or flammable vapours, unless
express authorisation has been given in writing by the manufacturer. If in doubt, consult your local
product dealer for further information.
Do not obstruct any slots or openings in the product. These are provided for ventilation to ensure
reliable operation of the product and to protect it from overheating.
Only use a damp cloth for cleaning (not liquid or aerosol based cleaners), and ensure that any power
is removed from the unit prior to beginning the cleaning operation.