Installation manual

Turning the Transceiver On/Off

Note: Out of the box the transceiver is turned “off” by default and should be turned “on” to

operate the alarm

• To turn “on” , press and hold button #4 until the transceiver chips two times. The power is

now “on”.

• To turn “off”, press and hold button #4 until the transceiver chips two time followed by

another two times. The power is now “Off”.

Note: When the Transceiver is in the “Off” mode only the and icons will still be

displayed

Operating Instructions

The following instruction assumes that the transceiver is with in range of the motorcycle.

Arm

1. Press button #1, siren chirps 3 times and the turn signal lights flash 1 time.

2. The Transceiver echoes 3 chirps and the LCD displays

and and PER OFF icons.

Disarm

1. Press button #2, siren chirps 1 time and lights flash 1 time.

2. The Transceiver echoes 1 chirp and the LCD displays icon.

Arming With Optional Perimeter Sensor

1. Press button #3, siren chirps 4 times and turn signal lights flash 1 time.

2. The Transceiver echoes 4 chirps and the LCD displays

, icons.

3. The system is armed and the perimeter sensor is activated.

Arming Without Siren / Paging Only

1. Press buttons #1 and #3 at the same time, siren chirps 5 times and the turn signal lights

flash 1 time.

2. The Transceiver echoes 5 chirps and the LCD displays

, and icons.

3. The system is armed but the siren and turn signal lights are disabled for a silent paging

only alert.

Arming Without Siren or Perimeter Sensor (optional) / Paging Only

1. Press buttons #2 and #3 at the same time, siren chirps 6 times and the turn signal lights

flash 1 time.

2. The Transceiver echoes 6 chirps and the LCD displays

, , and PER OFF icons.

3. The system is armed but the siren, turn signal lights and perimeter sensor are disabled.

Panic/ Stop Trigger

a. When system is armed press button #3 for Panic feature. (panic feature will

sound siren for a few seconds, drawing attention to your bike)

b. Pressing button #3 during an alarm trigger stops the alarm cycle but keeps

the system armed.

Note: When pressing button #1,2 or 3 the icon will flash to confirm the command has been

sent.