Service manual

SERVICE MANUAL- 1975 SCORPION BRUT
PISTON INSTALLATION
1. Place piston pin bearings in con -
necting rods.
• Position spacers at ends of bear-
ings.
• Lubricate bearing s.
See Fig. 1-1 8.
2.
Install one {1) snap ring in each
piston before placing pistons on
rods.
3. Slip pistons over connecting rods
holding bear.ings and spacers in
position.
4. Insert pi s ton pin through pi s ton,
bearing and spacers.
elnstall remaining snap ring .
See Fig. 1- 16, and 1-17.
PISTON RING INSTALLATION
Expand ring until it just slips over
piston.
Do not expand any further than
neces s ary.
Pos ition rings so that ring notch slid es
over ring locating pin .
See Fig. 1- 42.
1- 20
FIG. 1-42