Service manual

SERVICE MANUAL - 1975 SCORPION BRUT
4. Locate top dead center of the
pis t on travel.
5.
Set the dial indicator on z er o.
See Fig. 1- 50.
Rotate the crankshaft counter -
clockwise until' the indicator
read s .250".
Set the ohmmeter scale selector
at RX1.
Adju st the needle reading to 4 on
the resistance scale.
See Fig. 1-5 0.
6. Rotate the crankshaft clockwise
until the ohmmeter indicates a
sudden decrease in resistance.
This means that the points have
closed.
1- 26
The dial indicator should read
.150" to . 160". See Note.
If the dial indicator reads outside
this tolerance, adjust to within
tolerance by loosening the moun -
ting screws and rotating the
magneto (armature plate) in the
applicable direction.
NOTE: Timing is set at .150 - .160
full advance (340 Brut) when new
points are us ed to allow for
break-in of point rubbing blocks.
After approximately 3 hours of
operation, the timing should be at
.138 full advance (normal).
RESISTANCE RE ADING DROP
FIG. 1-52
DIAL INDICATOR RDG.
(.1 50 - .160)