Tribunus VII+ 200A ESC - Manual

14.0
Anti Spark DIY Kit manual
Page 16
ANTI SPARK DIY KIT
Scorpion Anti Spark DIY kit
www.scorpionsystem.com/files/download/AntiSparkDIYkit.pdf
Including parts:
How to install it:
3) solder the of the PTC Resettable
fuse
to the positive wire
1) remove the old heat shrink
5) modify the plastic tube (shorten it correctly and also cut it as shown in the picture)
6) slide the plastic tube over the leg of
the
PTC Resettable fuse and use
CA to keep it in position
8) bend the leg of the
PTC Resettable fuse as
shown in the picture like a “V”, cut the leg
if it's too long
Now connect the negative (-) wire first. Then connect the positive (+) battery wire to the PTC Resettable fuse for a second
and move straight into the positive connector. There will be no spark during connecting your battery to the ESC.
direct QR to online manual
4) apply a heat shrink over the connector to
isolate the other leg from the connector
9) Anti Spark DIY ready to use!
7) apply a heat shrink over it
2) wind one leg of the PTC Resettable
fuse around the positive (+) wire
from your ESC as shown below
1. PCT resettable fuse
2. plastic tube
3. heat shrink
This Anti Spark DIY can be used on 6S- 16S Lipo battery systems
Hope this DIY kit can help you on any spark issue during connecting a battery to an ESC.
heat shrink
plastic tube
PTC Resettable Fuse