Tribunus VII+ 200A ESC - Manual

Page 17
ANTI SPARK DIY FOR HOUSING CONNECTORS
14.1
Anti Spark DIY for housing connectors
How to install it:
3) solder the leg of the PTC Resettable
Fuse
to the positive wire
1) -cut the positive (+) wire that goes
from housing connector to the ESC
-solder the female connector as shown
on the housing connector side
5) modify the plastic tube (shorten it correctly
and also cut it as shown in the picture)
6) slide the plastic tube over the leg of the
PTC Resettable Fuse and use CA to
keep it in position
8) bend the leg of the
PTC Resettable Fuse
as shown in the picture like a “V”,
cut the leg if it's too long
Now disconnect the Anti Spark wire first. After that connect the battery to the housing connector. Then connect the positive (+) cable coming
from the ESC side to the
PTC Resettable Fuse for a second and move straight into the positive female connector.
There will be no spark during connecting your battery to the ESC.
direct QR to online manual
4) apply a heat shrink over the connector to
isolate the other leg from the connector
10) Anti Spark DIY ready to use!
7) apply a heat shrink over it
2) wind one leg of the
PTC Resettable
Fuse
around the positive (+) wire
as shown below
Required parts:
9) solder the male connector to the ESC
side and apply a heat shrink
1. PTC Resettable Fuse
2. plastic tube
3. heat shrink
4. male and female connector that fit
to your cable size and current
heat shrink
plastic tube
PTC Resettable Fuse
Hope this DIY kit can help you on any spark issue during connecting a battery to an ESC.
www.scorpionsystem.com/files/download/housingConnectorAntiSparkDIY.pdf
This Anti Spark DIY can be used on 6S- 16S Lipo battery systems
Scorpion Anti Spark DIY kit