Tribunus VII+ 200A ESC - Manual

Page 6
DEVICE MODE: If you would like to utilize the internal governor in the Tribunus ESC, select “Recalculated Value” for the rst few
ights with internal governor. Select the “Pre-stored value” after your rst few ights. Select “VBAR PID” for VBAR governor. Select
“External PID” for another external governor. Select “Airplane mode” for airplane use.
Default setting:
Device mode: PID with recalculated value. Communication protocol: Vbar.
BEC VOLTAGE: The BEC can be adjusted from 5.1V to 8.1V.
Rotation: Adjusts the motor rotation direction.
MAIN PAGE
MENU
Connect: Click to connect
or refresh the ESC to the PC
Program
Save: Saves current settings
to the ESC
Save cfg: Save current ESC
settings to le
Load cfg: Load ESC settings
from le
Log upd: Loads the log from
the ESC
Log save: Save the log to a
le
Log Load: Loads the log
from a le
Default cfg: Default factory
setting
NOTE: When the user
changes a value in any
dialogue box, the BLUE box
will turn RED. Once the user
clicks “SAVE”, the RED box
will turn BLUE once again to
signal that the value has
been stored to the ESC.
This is the page you can set up all the general setting like device mode selection, bec voltage, rotation direction
and communication protocol.
Communication Protocol: Select “Standard” if using Scorpion Internal Governor or Airplane
Mode.
Select VBar if using the Mikado VBar Control, Select “Jeti Exbus” if using a Jeti Exbus System,
select Unsc Telem if using an Unspecied Telemetry System (Such as JLog or Brain FBL) or
select Futaba Sbus 2 if using the Futaba Sbus 2.
12.1 General Setting
Device:
Model with the modication
name.
SN:
Serial Number
BL:
Boot Loader version
FW:
Firmware version
Reset code:
For engineer use.
Power on time:
Currently ESC running time.
Run count:
How many times did motor
run.
Motor time:
Total time of the motor run.
Discharge mAh:
Total capacity of battery did ESC
discharge.