Owner's Manual
Use
of
the Made for Apple badge means that an accessory has
been designed
to
connect specifically
to
the Apple product(s)
identified
in
the badge, and has been certified
by
the developer
to
meet Apple performance standards. Apple is not responsible
for the operation
of
this device or its compliance with safety and
regulatory standards. Please note that use
of
this accessory with
an
Apple product may affect wireless performance. Apple, iPad,
iPad Air iPad Pro, iPhone, and Lightning
are
trademarks
of
Ap-
ple, Inc., registered in the U.S. and other countries.
FCC
STATEMENT
This device complies with Part 15
of
the FCC Rules. Operation
is subject
to
the following
two
conditions:
(1)
This device may
not cause harmful interference, and
(2)
this device must accept
any interference received, including interference that may cause
undesired operation. This transmitter must not be co-located
or
operating in conjunction with any other antenna or transmitter.
Changes
or
modifications not expressly approved
by
the party
responsible for compliance could void the user's authority
to
operate the equipment.
This equipment has been tested and found
to
comply with
the limits for a Class B digital device, pursuant
to
Part 15
of
the FCC Rules. These limits are designed
to
provide
reasonable protection against harmful interference
in
a
residential installation. This equipment generates uses and
can radiate radio frequency energy and,
if
not installed and
used
in
accordance with the instructions, may cause harmful
interference
to
radio communications. However, there is
no guarantee that interference will not occur
in
a particular
installation.
If
this equipment does cause harmful interference
to radio or television reception, which can be determined
by
turning the equipment off and on, the user is encouraged
to
try
to
correct the interference by one
or
more
of
the following
measures:
Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
--
Connect the equipment into
an
outlet on a circuit different
from that to which the receiver is connected.
--
Consult the dealer or
an
experienced
radionv
technician
for help.
Radiation Exposure Statement: The product complies with
the FCC/IC
RF
Exposure for Low Power Consumer Wireless
Power Transfer.
RF
exposure limit set forth for
an
uncontrolled
environment and are safe for intended operation as described
in
this manual. The further
RF
exposure that compliance was
demonstrated at 20cm and greater separation from the user
body or set the device
to
lower output power
if
such function
is available.
IC
STATEMENT
This device complies with Industry Canada's license-exempt
RSSs.
Operation is subject to the following
two
conditions:
(1)
This device may not cause interference; and
(2)
This device must accept any interference, including
interference that may cause undesired operation of the
device.
The term "IC:" before the certification/registration number
only signifies that the Industry Canada technical specifications
were met. This product meets the applicable Industry Canada
technical specifications.