Owner's Manual
FCC
STATEMENT
This device complies with Part 15
of
the FCC Rules. Operation
is subject
to
the following
two
conditions:
(1)
This device may
not cause harmful interference, and
(2)
this device must accept
any interference received, including interference that may cause
undesired operation. This transmitter must
not
be co-located
or
operating in conjunction with any other antenna
or
transmitter.
Changes
or
modifications
not
expressly approved by the party
responsible
for
compliance could void the user's authority
to
operate the equipment.
This equipment has been tested and found
to
comply with
the limits
for
a Class B digital device, pursuant
to
Part
15
of
the FCC Rules. These limits are designed
to
provide
reasonable protection against harmful interference in a
residential installation. This equipment generates uses and
can radiate radio frequency ener
gy
and,
if
not
installed and
used in accordance with the instructions,
may
cause harmful
interference
to
radio communications. However, there is
no guarantee that interference will
not
occur
in a particular
installation. If this equipment does cause harmful interference
to
radio
or
television reception, which can be determined
by
turning the equipment
off
and on, the user is encouraged
to
try
to
correct the interference
by
one
or
more
of
the
following
measures:
--
Reorient
or
relocate the receiving antenna.
--
Increase the separation between the equipment and
receiver.
--
Connect the equipment into an outlet on a circuit different
from that
to
which the receiver is connected.
--
Consult the dealer
or
an experienced
radionv
technician
for
help.
Radiation Exposure Statement: The product complies with
the FCC/IC
RF
Exposure
for
Low
Power Consumer Wireless
Power Transfer.
RF
exposure limit set forth
for
an uncontrolled
environment and are safe
for
intended operation as described
in this manual. The further
RF
exposure
that
compliance was
demonstrated
at
10cm and greater separation from the user
body
or
set
the
device
to
lower output
power
if
such function
is available.
IC
STATEMENT
This device complies with Industry Canada's license-exempt
RSSs. Operation is subject
to
the following
two
conditions:
(1)
This device may
not
cause interference; and
(2)
This device must accept any interference, including
interference that may cause undesired operation
of
the
device.
The term "IC:" before the certification/registration number
only signifies that the Industry Canada technical specifications
were met. This product meets the applicable Industry Canada
technical specifications.
This equipment is not suitable for
use
in
locations where children are likely
to
be
present.
For complete warranty details,
please visit us
at
www.scosche.com
or
call
(800)
363-4490