Owner's Manual
FCC
STATEMENT
This device complies with Part 15
of
the
FCC
Rules. Operation
is subject
to
the following
two
conditions:
(1)
This device may
not cause harmful interference, and
(2)
this device must accept
any interference received, including interference that may cause
undesired operation. This transmitter must not be co-located
or
operating
in
conjunction with any other antenna
or
transmitter.
Changes
or
modifications not expressly approved by the party
responsible for compliance could void the user's authority
to
operate the equipment.
This equipment has been tested and found
to
comply with
the limits for a Class B digital device, pursuant
to
Part 15
of
the FCC Rules. These limits are designed
to
provide
reasonable protection against harmful interference
in
a
residential installation. This equipment generates uses and
can radiate radio frequency energy and,
if
not installed and
used in accordance with the instructions, may cause harmful
interference
to
radio communications. However, there is
no guarantee that interference will not occur
in
a particular
installation. If this equipment does cause harmful interference
to
radio
or
television reception, which can be determined
by
turning the equipment off and on, the user is encouraged
to
try
to
correct the interference by
one
or
more
of
the following
measures:
--
Reorient
or
relocate the receiving antenna.
--
Increase the separation between the equipment and
receiver.
--
Connect the equipment into an outlet
on
a circuit different
from that
to
which the receiver is connected.
--
Consult the dealer
or
an
experienced radio/TV technician
for help.
Radiation Exposure Statement: The product complies with
the FCC/IC
RF
Exposure for Low Power Consumer Wireless
Power Transfer.
RF
exposure limit set forth for
an
uncontrolled
environment and are safe for intended operation as described
in this manual. The further
RF
exposure that compliance was
demonstrated
at
10cm and greater separation from the user
body
or
set the device
to
lower output power
if
such function
is available.
IC
STATEMENT
This device complies with Industry Canada's license-exempt
RSSs.
Operation is subject
to
the following two conditions:
(1)
This device may not cause interference; and
(2)
This device must accept any interference, including
interference that may cause undesired operation
of
the
device.
The term "IC:" before the certification/registration number
only signifies that the Industry Canada technical specifications
were met. This product meets the applicable Industry Canada
technical specifications.
This equipment is not suitable for
use in locations where
ch
ildren are likely
to
be present.
For complete warranty details,
please visit us
at
www.scosche.com
or
call
(800)
363-4490