manual

1984-86 Chrysler Laser
1981-83 Chrysler Imperial
1979-81 Chrysler Newport
1979-83 Chrysler New Yorker
1979-81 Dodge St. Regis
Radio Removal:
1. Remove four screws securing the radio dash panel: two
above the radio and two above the heater controls.
2. Remove radio dash panel.
3. Remove two screws securing the radio to the dash. Pull
the radio out.
4. Disconnect power, antenna, and all speaker and electrical
connections.
REMOVE
ALIGNMENT
PIN - BOTTOM
USE THESE
SUPPORT
TABS AS
REQUIRED
USE THESE
SUPPORT TABS
AS REQUIRED
USE THIS
BRACKET
REMOVE
ALIGNMENT
PIN - BOTTOM
USE THESE
SUPPORT
TABS AS
REQUIRED
USE THESE
SUPPORT TABS
AS REQUIRED
USE THIS
BRACKET
Radio Removal:
1. Remove one screw from each side of the
ashtray.
2. Pull off the trim panel.
3. Remove two screws securing the radio to the
dash. Pull the radio out.
4. Disconnect the power, antenna, and all
speaker and electrical connections.
Read pages 2-4 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO AND SHAFT RADIO INSTALLATION, SEE PAGES 3 & 4.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO AND SHAFT RADIO INSTALLATION, SEE PAGES 3 & 4.
Read pages 2-4 for kit assembly.
REMOVE
ALIGNMENT
PIN - BOTTOM
USE THESE
SUPPORT
TABS AS
REQUIRED
USE THESE
SUPPORT TABS
AS REQUIRED
USE THIS
BRACKET
1987-93 Chrysler Le Baron "Coupe"
Radio Removal:
1. Remove two screws, one from each lower corner of the
radio/console trim panel.
2. Gently snap off the trim panel.
3. Remove two screws securing the right side panel of the
console, one at top, one at bottom; remove the side
panel.
4. Remove two screws from the radio mounting
bracket. Disconnect the wire harness, antenna
lead, and ground strap. Remove the radio.
Read pages 2-4 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO AND SHAFT RADIO INSTALLATION, SEE PAGES 3 & 4.
1994-97 Chrysler LHS
1994-96 Chrysler New Yorker
Radio Removal:
1. Remove the ashtray from the dash.
2. Carefully pry out on the perimeter radio dash bezel
using a panel removal tool to release the fastening
clips and remove the radio dash bezel.
3. Extract the two screws securing the radio to the
dash, pull the radio from the dash cavity, unplug all
connectors and remove the radio.
REMOVE
ALIGNMENT
PIN - BOTTOM
USE THESE
SUPPORT
TABS AS
REQUIRED
USE THESE
SUPPORT TABS
AS REQUIRED
USE THIS
BRACKET
Read pages 2-4 for kit assembly.
USE THE SHADED MOUNTING TABS AND THE INDICATED BRACKETS. CUT OFF THE REMAINING TABS AND DISCARD.
FOR DIN ISO AND SHAFT RADIO INSTALLATION, SEE PAGES 3 & 4.
8
9