Owner's Manual

STEREO REMOVAL
1. Using a panel removal tool, pry off the radio trim bezel.
2. Remove the (4) torx screws securing the radio to the dash.
Save these screws, they will be used
to install the new kit panel.
3. Unplug connectors and remove the factory radio.
STEREO INSTALLATION
NOTE:
REAR SUPPORT AVAILABLE
SEPARATELY. REAR
SUPPORTING THE RADIO
ADDS TO THE INSTALLATION'S
STRUCTURAL INTEGRITY.
.
/'
~
,.
',,- ' ..
~ .. 6393R
/'/' BRACKETS
/'
/'
6. Install the radio trim bezel.
ISO DIN MOUNT REAR
1. Snap the 6393L and 6393R brackets to the mounting locations on the 6388 kit panel. SUPPORT
2. Snap the 6391 pocket into the kit panel, and secure it to the 6393L and 6393R ~
brackets using the (2) screws supplied with the installation kit.
3. Position the aftermarket DIN ISO head unit between the 6393L
and 6393R brackets and attach it
to them using the
hardware supplied with the aftermarket radio.
4. Snap the 6390 trim ring over the radio.
5. Plug in radio harness and antenna,
slide the new kit into the dash, and
attach with the
(4) torx screws
removed earlier.
DOUBLE DIN MOUNT
REAR
SUPPORT
NOTE:
REAR SUPPORT AVAILABLE
SEPARATELY. REAR
SUPPORTING THE RADIO
ADDS TO THE INSTALLATION'S
STRUCTURAL INTEGRITY.
REMOVE TAB
BOTH SIDES
6393L'~'"''
BRACKET "", "
, ~
" ., ..
" ·~i~,
~
1. Remove 90 degree pocket mounting tabs from
6393L and 6393R brackets.
2. Snap the 6393L and 6393R brackets to the
mounting locations on the 6388 kit panel.
3. Position the aftermarket DOUBLE DIN ISO head
unit between the 6393L and 6393R brackets and
attach it to them using
the hardware supplied
with the aftermarket
radio.
4. Snap the 6389 trim ring
over the radio.
5. Plug in radio harness
and antenna, slide the
new kit into the dash,
and attach with the
(4)
torx screws removed
earlier.
6. Install the radio trim
bezel.
2