Owner's Manual

ManualsBrandsScosche ManualsAudio accessories & installationDash and Wiring Kit

Table Of Contents

IN-DASH INSTALLATION KIT FOR

2015-UP FORD

MUSTANG

FD6210B

SINGLE ZONE MANUAL

CLIMATE CONTROLS

KIT CONTENTS

Face

Panel

*w/ UAC (7773)

2. Right Bracket {7774)

Left Bracket (7775)

Three Button

Switch

Trim

(7776)

5. Back Cover (7778)

PCB Spacer

(7779)

Pocket (6761)

**Dash Modification Required**

Tools

Required

• PRT (Panel Removal

Tool)

•

Screwdriver

•

Rotary Cutting

Tool

•

Filing

Tool

,,,

'1::._

NOTICE:

Extremely high temperatures may

::-

temporarily affect the display. Normal

operation

wilt

resume once the unit

cools.

INTRODUCTION

PRELIMINARY

This premium

installation

kit

for 2015-UP

Ford Mustang vehicles with single zone manual climate controls (dash

modification required).

Included are

all

the parts you need to mount your

car stereo or CD player into your vehicle's dash.

Refer

individual instruction

this manual

remove your vehicles factory radio and assemble the kit.

CAUTION:

DISCONNECT

YOUR

VEHICLE

NEGATIVE BATTERY TERMINAL

BEFORE

THE

INSTALLATION

HELP PREVENT

ELECTRICAL

DAMAGE.

RECOMMEND

THE

USE

A VOLT!

OHM

METER

OVER

A TEST LIGHT

CHECK

WIRING. A TEST LIGHT

GROUNDED

WIRE

PROBE

CAN CAUSE

DAMAGE

THE

VEHICLE'S COMPUTER

AND/OR

DIAGNOSTIC SYSTEMS. AVOID

ALL

FACTORY

AIRBAG WIRING

AIRBAGS

CAN ACCIDENTALLY DEPLOY CAUSING SERIOUS INJURY

DEATH.

NOTES-------------------------------------------------------

•

See

your

vehicle's

instructions for any special

tools

your

installation

might

require.

•

Read

all

instructions accompanying your car stereo for proper wiring and

mounting

instructions.

LIABiliTY

DISCLAIMER

This

instruction booklet

based on

carefully

documented data and research

automobile disassembly,

wire harness/codes

and information pertaining

the installation

this kit. Scosche

Industries, Inc.

cannot be held responsible for discrepancies/

inconsistencies

that

may occur due

the automobile manufacturing changes or options, or damage that may occur in the

automobile

during

the

installation

components while using this

booklet.

you

have any

further

questions,

call

our

toll

free

technical

help

line

at:

2016

SCOSCHE INDUSTRIES, INC.

1-800-621-3695x3

FD621

12/16

Summary of content (19 pages)

PAGE 1
FD6210B IN-DASH INSTALLATION KIT FOR 2015-UP FORD MUSTANG SINGLE ZONE MANUAL CLIMATE CONTROLS **Dash Modification Required** KIT CONTENTS 1. Face Panel *w/ UAC (7773) 2. Right Bracket {7774) 3. Left Bracket (7775) 4. Three Button Switch Trim (7776) 5. Back Cover (7778) 6. PCB Spacer (7779) 7. Pocket (6761) Tools Required • • • • PRT (Panel Removal Tool) Screwdriver Rotary Cutting Tool Filing Tool ,,, '1::._~ NOTICE: Extremely high temperatures may ::- temporarily affect the display.
PAGE 2
INSTALLATION GUIDE Disassembly Image A: Remove the two (passenger and driver side) knee panels on the lower console. Image B: Next remove two exposed screws. Image A: Using a PRT (Panel Removal Tool) Carefully remove the tray located below the USB and 12v socket ports, then remove and retain two screws exposed. Image B: Lift and slightly pullback the center cup holder console but do not remove.
PAGE 3
INSTALLATION GUIDE Disassembly Remove the four screws securing the OEM panel to the dash; then unplug and remove the panel (See image on right side). Remove the OEM Display and the CD receiver by unscrewing the four screws for each component (8 screws total, circled); then unplug all wiring and remove (See image on the left). INSTALLATION GUIDE IHIIIIIII CAUTION ~~~~~ Step7 Major modifications required for double DIN installation.
PAGE 4
INSTALLATION GUIDE StepS Assembly I Mounting Assembly I Mounting Remove fifteen screws and the 12v socket located behind the OEM climate control panel and retain for later install ; then remove the PCB board back cover. NOTE: • The amount of screws may vary with each model. ·The 12v socket retained may be placed on the aftermarket panel once removed from OEM panel Step9 Assembly I Mounting Remove the seven screws securing the PCB board to the panel; then remove from the panel.
PAGE 5
INSTALLATION GUIDE Step 12 Assembly 1 Mounting Assembly I Mounting Place the drive train/ ignition control trim into the (7773) face panel Step 13 Assembly I Mounting • Place the OEM drive train/ ignition control buttons (retained in Step 11) into the trim from Step 12. • Next Place the three provided PCB spacers Indicated by arrows on top of button controls.
PAGE 6
INSTALLATION GUIDE Assembly I Mounting Assembly I Mounting NOTE: Use the screws attained from the OEM PCB cover plate. INSTALLATION GUIDE Step 17 Assembly I Mounting Assembly I Mounting Double DIN: Single DIN: Attach both provided brackets Brackets to the aftermarket radio. Attach both brackets provided to the pocket and then secure the radio to the brackets. Assembly I Mounting lit§·IPI Assembly I Mounting Reassemble everything in reverse order to complete the installation.
PAGE 7
STEERING WHEEL CONTROL DIAGRAM The Scosche FD621 08 (2015-UP Ford Mustang) face panel comes with a steering wheel control harness that will retain the vehicles OEM steering wheel capabilities when equipped. Refer to the HVAC wiring diagram for a connection guide. For further or more detailed understanding of the steering wheel controls, please refer to your vehicles owner manual for button functionalities. Figure 1 / 1. Track I Seek UP 2. Volume UP 3. Track I Seek UP 4. Volume Down 6. Mute 7.
PAGE 8
FD621 OB WIRING DIAGRAM - :,_., Figure 2 Wiring Codes White= White/ Black= Green= Green/ Black= Black= Yellow= Red= Blue/White= To 8<1c• of the p, sh-St"r' Module Left Front Positive {LF+) Chassis Ground Gray= Gray/ Black= Violet= Violet/ Black= Orang e= Right Front Positive (RF+) Right Front Negative (RF-) Right Rear Posit i ve (RR+) Right Rear Negative (RR-) Illumination + 12V Constant Power Lt.
PAGE 9
STEERING WHEEL CONTROL DIAGRAM Figure 3A w~r r ---r----n_ - - - - - - - - ~-----------------~~ 0 ~ I I~ ~ li M,M~ 1. P repare SWC steering wheel connector harness by using the chart below 2. C onnect the harness to the interface module. 3. For Alpine, Clarion, JVC, Panasonic and Sony car stereos, connect the 3.5mm male steering plug into the steering wheel input jack at the back of the stereo. 4.
PAGE 10
CLIMATE CONVENIENCE CONTROL · -,. ~- The Scosche Touch Screen Interface replaces the Factory climate, convenience and personalization controls built into the Factory Ford Radio/Dash panel. This solution prov1des improved ergonomics while adding touch screen capabilities unique to this system. Read the following sections to familiarize yourself with the operating controls and settings. FIGURE 4 )<-~-CONTROL PANEL BUTTON LAYOU~... : _ _:__/ ~ 2 ~ ~-~11 >---Hi=:,:-~ ~j- ;' -~ ~: 3 r ® ~ c ~ -.
PAGE 11
CLIMATE & CONVENIENCE CONTROLS Figure 5 9 10 I 1- - -MAX(l 6 8 3 1. 2. 3. 4. 5. 4 5 Max AC Fan Speed Indicator Vent Air Direc tion Driver Hea ted Seat Pass. He ated Seats 6. 7. 8. 9. Temp . Warm Temp. Indicator Temp. Cool Outside Temp . Reading 10. Time TEMPERATURE CONTROL Usc the UP and DOWN arrows (Fig. 5. #6 & #8) on the color TFT touch screen to adjust vehicle air temperature. Touch the Red arrow to increase air temp. Touch the Blue arrow to decrease air temp.
PAGE 12
VEHICLE FEATURE I SETTINGS . Figure 6 1 - LCD Usc car dimmer control? 2- Button 3- Setup ( Yes I Use car controls to test 4 Day II Night I[ Auto Brightness LCD Day ~E[==3]I[11l]J11180 Night .__.,.. w1""311111] Day 5 jI )[_, Night 6 II Auto ) 8 7 Figure 8 & 9 Key 1. 2. 3. 4. LCD- Select from the options listed Day I Night I Auto (F1g. 6: #'s6 ·8) to adjust the brightness levels of the LCD. Use the slide bars (Fig. 6; 115) to d1m or brighten the display screen.
PAGE 13
VEHICLE CONFIGURATION SETTINGS CHART Use the chart below to navigate through the different settings the "Setup" touch button has to offer. Also use the chart to see the different configuration settings offered with the kit. ACCESSING INSTALLER MENU 1. To access the installer menu press and fJold physrcal ..Set" Use car drnlr''€' control? button on the bottom right of UAC module (See page 11; Figure 4, #8). ~ 2. After 1 Osee of holdrng down "SET" button.
PAGE 14
NOTES 15 FD6210B 12/16
PAGE 15
NOTES 16 FD621 OB 12/16
PAGE 16
NOTICE: Extremely high temperatures may temporarily affect the display. Normal operation will resume once the unit cools.
PAGE 17
FD62tOB FORD MUSTANG. 20tS·UP. Single-Zone Glftlate CoMtol Models I n t e g r a t e d - Co•llol Solation Dash Kit • Double DIN I Single DIN with pocket · FEA1VR&S • Built.fn Advance ColotTouch-scteen Conttol System Retains: • Sinata ~aimate Controls • Steetlng Wheel CcMittOls • Heated Seats (If EQuipped) • Veltide OEPersonarazatfoft Menus & Setting • Accommodates OEM,_..
PAGE 18
FD6210B FORD MUSTANG, 2011·UP Slngi•Zone Climate Control Models lnte1rated Touchscreen Control Solution Dash kit • Double DIN I Single DIN with pocket FD6210B ·
PAGE 19
www.scosche.com 800·621·3695 x3 OESIGittO &bCUitERED ttl USA tit seGStiiE FD6210B COt.OR: GUN MnAt. STOP e OUimOII WITH A.SEMIL'f OR IIITAWnOit e IEII PARTS IIFORMAnOI? tf you tteve any futthet lnataldoft queatlona. eatl! MAIUfACIUIIEft WARIIAin. 10 liED TO RmRI TO STORE! aoo.621.a6t5 eat.3 e tHIS PRODUCT II UIDER ,..CH HELP Visit our website: .www.scoscbe.com . Hours to call: Monday .. Friday 8:00am· 6:30pm (PST) C 2016 SCOSCHt INDUSTRIJ:S, tNC.