Manualshelf

Owner's Manual

ManualsBrandsScosche ManualsFM transmittersFM-MOD02
123456
FMMOD02
AUXILIARY
INPUT I
FM MODULATOR
PARTS
INCLUDED:
(1)
FM
modulator
(1)
Switch plate
(1)
3.5
to
3.5 audio cable
(2)
11''
zip ties
(4)
7.5"
zip ties
(1)
Double-sided tape
RECOMMENDED
TOOLS:
• Phillips screwdriver
• Panel removal tool
• 10mm socket and ratchet
• Dri
II
and bits
• Pliers
READ
AND
UNDERSTAND THESE INSTRUCTIONS BEFORE
ATTEMPTING
TO
INSTALL
THIS PRODUCT.
INSTALLATION
PRELIMINARY:
This
device
is installed
behind
the
radio.
1. Remove the radio
to
gain access
to
the antenna plug. Contact Scosche tech
support for assistance with radio removal:
1-800-621-3695
Ext.
3.
2. Disconnect
the
antenna from the factory radio then plug
it
into the female
antenna connection on the
FMMOD02.
3. Plug the male antenna plug from the FMMOD02 into the antenna slot on the
back
of
the radio.
Note:
If the antenna plug
of
the FMMOD02 plug does not fit into the back
of
your radio, please contact Scosche tech support for application support.
4. Locate a suitable location
to
mount the FMMOD02 switch plate. You can use
the
zip ties
to
mount the modulator. Hint: Keep
in
mind the length
of
the
cables.
5. Connect the
RED
power wire
to
a + 12v ignition
or
accessory power source.
This power can usually be found behind the radio or
at
the fuse box. For
assistance contact Scosche tech support.
6. Connect the BLACK ground wire
to
a ground wire behind the radio or
to
chassis metal
of
the vehicle. For assistance contact Scosche tech support.
7. Connect the
RED
and WHITE RCA cables
to
your auxiliary input on the
FMMOD02. Use the supplied 3.5mm
to
3.5mm audio cable
to
listen
to
your
media
for
most MP3 players.
@2008 SCOSCHE INDUSTRIES, INC.
Sl -
9/08
300FMMOD02

Summary of content (6 pages)