Owner's Manual

INSTALLATION GUIDE Disassembly
Step4
D is assembly
Remove the two screw from each
air vents, then unclip and remove
(dash shaded area). The remove the
two screws exposed inside the vent
cavities.
With
the panels detached remove
the four screws holding the radio
cage in place. Release the cage
from below the climate control
panel.
INSTALLATION GUIDE Kit Assembly
Step 1
Kit Assembly
,
Mount brackets (2) to the sides of the aftermarket head until with the units
pre-existing screws. (*Only
if installing a single DIN radio, mount the included
pocket to the brackets at this point)
Step 2
Kit Assembly
Position the head unit and bracket assembly into the holde beneath the climate
control unit (Step 3 on Page 2
of the "Disassembly"). Following this, place the
trim panel around the new head unit and fix in place with
the supplied screws.
Step 3
Kit Assembly
Reassemble
Dash
in reverse order to complete the installation
3
GM5216B 01/1 6