Owner's Manual

1999-02 GM TRUCK & SUV Disassembly
Step 5
Disassembly
Disconnect your vehicle's negative
battery terminal. Next, unclip then
disconnect and remove the factory
stereo from its location.
CAUTION: Disconnect your vehicles negative battery terminal before the installation
to help prevent electrical damage. We recommend the use of a volU ohm meter over
a test light to check wiring. A test or grounded wire probe can cause damage to the
vehicle's computer and/or diagnostic system. Avoid all factory airbag wiring - airbags can
accidentally deploy causing serious injury or death.
• See your vehicle's instructions for any special tools your installation might require.
DASH CAVITY MODIFICATION Preparation
Modification Required: Please read the following instructions before proceeding.
Location modification required for this installation, proceed with CAUTION! Modification
required for full-size aftermarket radios. If you are unsure or feel that the installation is to
difficult, we recommend you seek professional installation. Note that additional installation fees
may apply and vary by location. Scosche is not responsible or liable for any additional fees or
modifications done by the installer.
Step 6
Preparation
Carefully use a cutting tool to cut the plastic shelf located in the radio dash cavity, avoiding all
wires. Reference the illustration on the below for modification area details.
I
If you have any questions or need technical assistance with the installation,
or the most current application please call or visit us on the web at:
■ [phone] x1 I www.scosche.com/contact
©2018 SCOSCHE INDUSTRIES, INC
3
GM5602DDB 08/18