Owner's Manual
Table Of Contents
KIT
PANEL
ASSEMBLY
ILLUSTRAnON 1
...
ILLUSTRAnON 2
ILLUSTRAnON 3
A. ATTACHING ISO BRACKETS
For ISO installation, attach ISO brackets to panel with
(4)
supplied screws, (See Illustration
1)
B. ATTACHING
THE
POCKET
1,
Align the pocket to the lower edge
of
the opening in
the panel. Slide pocket
in,
as shown, The front
of
the
pocket should rest flush
to
front
of
panel.
(See Illustration
2)
2.
Install'(2) pocket screws as shown. (See Illustration
2)
'"
C. MOUNTING THE STEREO
(SINGLE ISO DIN INTALLATION)
Align and position the ISO-DIN head unit. Secure
in
place using hardware supplied with the aftermarket
stereo. (See Illustration
3)
D. MOUNTING THE STEREO (2 SINGLE ISO DIN
OR DOUBLE ISO DIN INSTALLATION)
1. For ISO installation, attach ISO brackets
to
panel with
(4)
supplied screws.
2.
Align and position the,two ISO-DIN head units or
one Double
Di'n
head unit. Secure in place using
hardware supplied with the aftermarket stereo.
(See Illustration
4)
ILLUSTRATION 4
FACTORY
STEREO
REMOVAL
2008-UP
HONDA ACCORD
1.
With panel removal tool unsnap & remove dash trim pieces to either side
of
radio revealing
(2)
Phillips screws.
2.
Remove
(2)
Phillips screws.
3.
With panel removal tool,
pry
up and unsnap center console
top
bezel, !;tartingat armrest-storage and moving
toward dash .
.'
'.
.
4. Remove
(4)
Phillips screws from
top
and bottom
of
pocket below radio
5.
Unsnap trim surrounding shifter and move shifter and trim back
(1
st gear) using shifter override button (be
sure parking brake is set).
6.
Remove pocket.
7.
Extract
(2)
8mm screws from underside
of
radio.
8.
With panel removal tool remove radio and associated panel.
9.
Unplug and remo,,;eradio.
2