Owner's Manual

VEHICLE ASSEMBLY
8. Connect the provided power I-harness
according to the diagram displayed in
the Test Connection box at the top of
page 6 or illustration at right. Connect
the female and male 12V power
connectors first then route the type-c
connector to the designated slot
created during the preparation step at
the bottom of page 6.
9. With the power connected to the
I-harness, route the type-c connector
under the shifter panel and through the
hole created in the preparation step on
page 5, and lastly through the HAQ02
Qi bezel.
Note: Tuck away any excess cable
under shifter panel. away from the
shifter.
10. Use the provided two-sided adhesives
to secure the panel/module from
moving then connect the Qi module to
the type-c connector. Once the
module is connected place it into the
bezel then reconnect everything in
reverse order of the disassembly to
complete the installation.
Lastly, place your Qi
enabled device onto
the HAQ02 assembly
to charge your device.
Refer to LED Charging
Status for charging
details (page 6).
(!), .--------------,
Female Connector to To QI Module
12V harness connector (MQUSM)
: :r~-cn ♦
Male Connector to
Back of 12V Socket