Owner's Manual

KIT ASSEMBLY
REMOVE SLEEVE FROM AFTERMARKET STEREO
1. Locate the locking mechanism on your DIN stereo sleeve
{typically) on the side.
2. Slip mounting sleeve towards rear
of stereo
and remove {Figure
1). FIGURE 1
ISO-DIN MOUNT ONLY
1. Attach the 7 423 and 7 424 side brackets to the 7 422 front
panel using the hardware supplied with the kit (Figure
2).
2. Remove supplied trim ring and sleeve from new stereo.
3. Slide new stereo into kit from rear and fasten within the kit's
brackets using the ISO hardware provided with the stereo.
NOTE: If hardware is not included with aftermarket stereo,
reuse factory hardware.
STEREO MOUNTING BOLTS
(re-use
bo l ts from factory stereo)
FIGURE 2
7424 LEFT
MOUNTING
BRACKET
7422 PANEL
BRACKET MOUNTING SCREWS
'
'
'
'
I
(s upp lied with HD7000B dash ki t) ______ .:....._ ___,
7423 RIGHT
MOUNTING
BRACKET
' ~-----'
7501 SPACER
(Road Gli
de
models only)
NOTE: Due to variances in motorcycle manufacturing, the HD7000B dash kit includes a strip
of Neoprene gasket material for optional use. If you experience a gap around the perimeter of
the faceplate then use the supplied adhesive backed gasket strip to seal the space.
6