Owner's Manual

INSTALLATION GUIDE Panel Preparation
NOTE Panel Preparation
PCB: 3 BUTTON + START PCB : 4 BUTTON + START
STIP 12 Panel Preparation
Place the three orfour button drive-train/
ignition control trim (777 6 / 7777) into the face
panel (Based on vehicle model type).
NOTE : Image image of panel on right is ba s ed on three button.
STEP 1 S Panel Preparation
Place the OEM drive - train/ ignition control buttons
(retained in Step 11) into the trim from Step 12 .
Next, place the three provided PCB spacers indicated
by arrows on top of button controls.
STEP 14 Panel Preparation
Place the rubber pad from the OEM
drive-train controls onto the back of the
buttons being caut i ous not to knock over
the spacers placed on previous step .
NOTE: 4- Button displayed, follow same
procedure for 3- button
STEP 15 Panel Preparation .
Carefully align the circuit board over the rubber
pad, then continue to the next step.
()2 021 SCOS CHE INDU ST RIE S, IN C.
5
3- Button displayed , follow same procedure
for 4- button
IT CFDOSAB 10 /2 1