Owner's Manual

ITCFDOSAB WIRING DIAGRAM LEGEND
FIGURE 2 WIRING DIAGRAM LEGEND
A. Connect to the back of the Push - Start module
B. Connect to aftermarket radio (See WIRING COLOR CODES below)
C. Vehicle Speaker Wires Connector (Color codes below)
* If the vehicle has Shaker Audio then the Shaker interface should be connected to C and L
should be plugged into the other end of the interface .
D. Connect to vehicle factory rad io chass is
E. Steering Wheel Controls (See Page 7 for more details)
F. Connect to the back of the UAC.
G. Reverse video (RCA, Brown)
H. Connect to vehicle harness Behind Screen for both
4.2' and 8' monitors (Attach to Sync box)
I. Audio Aux (RCA, White)
J. AUDIO Aux (RCA, Red)
K. For use with 4.2' monitor connectors only.
L If the vehicle has Shaker Audio then the Shaker interface should be connected to C and L
shou ld be plugged into the other end of the interface .
M. Connect to aftermarket radio (See Color Codes Below)
N. Connect to aftermarket radio's AMP remote (Blue/White)
0. Connect to aftermarket radio's AMP remote (Blue/White)
P. Connect to C (For use with Non Shaker systems On l y)*
Q. Connect the speaker wires from the after market radio to the wires at Q (For use with Non Shaker systems Only)*
WIRING COLOR CODES
White=
White/Black=
Green=
Green/Black=
Black=
Yellow=
Red=
Blue=
Blue/White=
Gray=
Left Front Positive (LF+)
Left Front Negative (LF-)
Left Rear Positive (LR+)
Left Rear Negative (LR-)
Chassis Ground
+ 12V Constant Power
+ 12V Accessory
+ 12V Power Antenna
AMP Remote
Right Front Positive (RF+)
Gray/Black=
Violet=
Violet/Black=
Orange=
Lt. Green=
Purple/White=
Brown=
Pink=
DIP SWITCH
• For Pioneer set 14 to ON (Down)
• For Sony set 14 to OFF (Up)
• All other brands #1,2,3,4 to OFF (Up)
© 2021 SCOSCHE INDUSTRIES , IN C.
8
Right Front Negative (RF-)
Right Rear Positive (RR+)
Right Rear Negative (RR-)
Illumination
Park Brake
Reverse
Mute
Speed Pulse (VSS)
1 2 3 4
DIP ON~
ITCFD0SAB 10 /2 1