Owner's Manual

1. Unscrew the shifter knob.
2. Using a panel removal tool, pop out the shifter panel. Disconnect and remove.
3. Remove two (2) screws from under this panel.
4. Using a panel removal tool, pop out the CD player panel from bottom to top. Disconnect and remove.
5. Remove six (6) screws from behind this panel.
6. Using a panel removal tool, pop the navigation screen panel. Disconnect and remove.
7. Remove two (2) screws from the radio. Disconnect and remove
RADIO REMOVAL
NOTE:
Keep all hardware from A/C controls and pocket to be used to reattach to kit panel.
A. ATTACHING A/C CONTROLS
Reattach the A/C controls to the kit panel using existing hardware.
B. ATTACHING POCKET
Reattach factory pocket to kit panel using existing hardware.
C. ATTACHING CLIPS
Carefully remove spring clips from dash panel and reattach
to kit panel.
POCKET ASSEMBLY
5651
MOUNTING
KIT PANEL
RADIO’S
SUPPLIED
TRIMPLATE
RADIO’S
MOUNTING
SLEEVE
REAR MOUNTING
SUPPORT BRACKET
DIN
RADIO
NOTE:
REAR SUPPORT AVAILABLE
SEPARATELY. REAR
SUPPORTING THE RADIO ADDS
TO THE INSTALLATIONS
STRUCTURAL INTEGRITY.
2
MOUNTING THE RADIO
BEND TABS
OUTWARD
5324 REAR
MOUNTING
SUPPORT
NOTE: Nissan factory bracket modification.
The factory Maxima brackets must be slightly modified to allow proper clearance for the DIN radio
mounting sleeve. The factory radio bolt "indents" on the inside of the factory bracket must be flattened out
in order to provide clearance for the DIN radio's mounting sleeve. Use a hammer or blunt object to faltten
out (2) indents on each bracket. (See Illustration)
LEFT
FACTORY
BRACKET
(INSIDE)
FATTEN
INDENTS
(INSIDE)
FATTEN
INDENTS
RIGHT
FACTORY
BRACKET