Owner's Manual

PSM21007
VERTICAL WHIP MOUNT (90°)
INSTRUCTIONS
STEP 1
Choose a mounting location (A).
STEP2
Position & mount Adjustable Whip Mount base to the
appropriate sized clamp ring for the vehicle by clicking
clamp rings into the base
(B*). Then use a 3/16" hex
key
to fasten the screw & nut included with the
ring clamp
(C). Continue until clamp is
tight and does not move.
Note: Do not exceed 200 inch-pounds.
STEP3
Mount whip as per manufacturer's
instructions.
Clamp Removal:
In-order to remove the clamp from location, the clamp must first be
tightened to allow base removal. Once tightened, loosen the clamp and
carefully squeeze clamp
to remove from the location.
Note: Use protective film to help avoid damage to the paint.
*Various ring clamp sizes available (sold separately
w/ hardware).