Owner's Manual
DEVICE
SETUP
GUIDE
MOUNTING ADAPTER
for
GoPro®
Requires
GoPro
~
camera
with waterproof case (not included).
1. Attach
ball adapter
to
the
mounting base as show below.
2. Place the camera case onto the adapter so
that
the
two
mounting brackets on
the
case
fit
between the
(3)
mounting
brackets on the adapter
as
shown
(A).
Make sure the holes
on both sets
of
brackets are aligned.
3.
Insert the threaded end
of
the clamping arm into the
bracket
holes
(B)
, and thread into the threaded nut
at the opposite end and tighten
until snug
(C).
Loosen the arm
to
adjust the angle
of
the camera.
PSM31001
1/4
" THREADED MOUNTING ADAPTER
for devices with a 1/4' threaded mount
1. Attach the ball adapter
to
the mounting base as shown on the
following page.
2.
Screw the 1/4" threaded mounting adapter directly into the 1/4"
mounting
hole on device.
Camera/Go Pro®
Mount
Base
STEP
1
Choose a mounting location
(D).
STEP2
Mount base
to
the
appropriate sized clamp ring
for
the vehicle (E*).
Note: Do
not
exceed 200 inch-pounds
STEP3
Position the base into location
by
clicking
clamp
rings into
the
base.
Then use a
3/16"
hex key
to
fasten the screw &
nut
(F) included with
the ring clamp*. Continue until
clamp
is
tight and does
not
move.
Note: Do
not
exceed 200
inch-pounds
STEP4
Tighten/Loosen the ball and hinge
joint
using the mounted turn
knob
(G)
on
the
mount
base.
Note: Use
the
knob
to
loosen, tighten
or
switch-out
the
1/4"
-20
screw
mount
(I)
or
the
Go
Pro®
mount
(H
).
Clamp Removal:
In-order
to
remove the tube clamp from location, the clamp must
first be tightened
to
allow base remova
l.
Once tightened, loosen
the clamp and carefully squeeze
clamp
to
remove from the
location.
Note
: Use protective
fi
lm to
hel
p avoid damage to the p
ai
nt.
*Variou
s
ri
ng cla
mp
si
zes
available (sold
se
para
te
ly w/ hardwa
re