Owner's Manual

ManualsBrandsScosche ManualsAudio accessories & installationDash Kit

Table Of Contents

scoscu~”

142TA2047B

IN-DASH INSTALLATION KIT FOR

ZOOI-UP TOYOTA RAV4 /

2000~UP MR2 SPYDER

OF YOUR CAR STEREO

TO FACTORY WlRlND

Front Speaker and PowePlug

Rear Speaker Plug

1 = Right Fronl Negative

2 = Lefl Front Negathre

3 - Accessory +12V

4 D +12V Constant, Battery

5 I Right Front Positive

1 = Right Rear Negative

2 = Lelt Rear Negative

3 = Right Rear Positive

LIABILITY DISCUIMER

mls instrucuoi~ booklet

b based M carefully dccumenled data and research of stifle dash dbasseml?dy, wire harnesakodas and

inlormaucn perrslnln~ lo lnslsllstkm 04 lhb WI (142TA2047B) In 2001~UP Toya RAV4 I2COO-UP MA2 Spyder vehkbz Scogche

Induslrbs, Inc. can nol be held respwelbb IM discrepancbsMwnsblencbs (hat may occur due lo the aulomoMe manulacluring

champs or q%me.. or damepe lhal may occur h the autanoMb dudng (he lnslallauOn ol componenb whlb uslno lhb booklet

If you have any further questions, call

%301 SCOSCHE INDUSTRIES. INC.

TECH HELP I-800-621-3695, ext. 3

SI 9x)1-142TA2047B (3000005)

Summary of content (4 pages)

PAGE 1
42TA2047B scoscu~” IN-DASH INSTALLATION KIT FOR ZOOI-UP TOYOTA RAV4 / 2000~UP MR2 SPYDER OF YOUR CAR STEREO TO FACTORY WlRlND Front Speaker and PowePlug 1 = Right Fronl Negative 2 = Lefl Front Negathre 3 - Accessory +12V 4 D +12V Constant, Battery 5 I Right Front Positive Rear Speaker Plug 1 = Right Rear Negative 2 = Lelt Rear Negative 3 = Right Rear Positive LIABILITY DISCUIMER mls instrucuoi~ bookletb based M carefully dccumenled data and research of stifle dash dbasseml?dy,wire harnesakodas and
PAGE 2
This premium installation kit is for 2000-Up Toyota MR2 Spyder and 2001-Up RAV4 vehicles. Included are all of the parts you need to mount your car stereo/cassette or CD player intq your vehicle’s dash. Reler to the individual instruction in this manual lo remove your vehicle’s factory radio and assemble the kit. CAUTION: Disconnect your vehicle’s negative battery terminal before the lnstallatlon to help prevent electrical damage. We recommend the use of a volt/ohm meter over a test light to check wlrlng.
PAGE 3
RAV4 BRACKET INSTALLATION 1, The bracket is only used for installation in Toyota RAV4. 2. Align the snaps of RAV4 mounting bracket with the pocket slots. 3. When aligned, snap bracket carefully into position until locked. STRUCTURAL BACK VIEW OF POCKET INTEGRITY. 2000.UP TOYOTA MR2 SPYDER RADIO REMOVAL AND IN-DASH INSTALLATION: Note: The factory radio provision is for a Double ISO/DIN style radio. 1.
PAGE 4
2001.UP TOYOTA RAV4 RADIO REMOVAL AND IN-DASH INSTALLATION: Note: The factory radio provision is for a double ISO/DIN style radio. 1. Extract (4) 5mm Hex screws from radio trim bezel and pry off using panel rem&al tool. 2. Extract (4) 1Ommbolts securing radio, pull away, disconnect, and remove. USE THESE TABS REAR SUPPORTtNG THE RADIO ADDS TO THE INSTALLATION’S I “SE TNE BHAOEO MOUNTING TABS.