Owner's Manual

Table Of Contents

This premium installation kit is for 2000-Up Toyota MR2 Spyder and 2001 -Up RAV4 vehicles. Included

are all of the parts you need to mount your car stereo/cassette or CD player intq your vehicle’s dash.

Reler to the individual instruction in this manual lo remove your vehicle’s factory radio and assemble the

kit.

CAUTION: Disconnect your vehicle’s negative battery terminal before the lnstallatlon to help

prevent electrical damage. We recommend the use of a volt/ohm meter over a test light to

check wlrlng. A test light or grounded wire probe can cause damage to the vehicle’s

computer and/al’ diagnostic systems. Avoid all factory alr bag wiring - alr bags can

accidentally deploy causing serlous InJury or death.

NOTES:

l See your vehicle’s instructions for any special tools your installation requires.

l Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting

instructions.

DIN RADIO INSTALLATION (DETACHABLE FACE/PULLOUT)

Slide the mounting sleeve (metal shroud) into the panel’s radio opening and bend all available mounting

tabs outward (see inset). Once the radio mounting sleeve has been fastened to the kit panel, slide the

radio into Ihe mounting sleeve until il locks into place.

NOTE: The mounting sleeve must be removed from the radio first1

Your radio may be snapped into its sleeve. Slide the mounting

sleeve (metal shroud) off the radio towards the back.

REAR SUPPORTING THE

RADIO ADDS TO THE

INSTALLATION’S

TRIM RINQ