) sconce Tattoo 2005-15 Toyota Tacoma Qi Center Console Direct Fit Bezel PARTS INCLUDED 1. {1) Direct Fit Bezel w/ USMC 2 (1) Vehicle Specific Thames 3. (2) MAQICPLATE™ 4. (2) MAGICPLATE™ Applicator 5. {6) Double-sided Adhesive HEAD INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS MOUNT KIT. WARNING: Do not uss the magnetic mount with any hard-drive based devices such I Pod classic, I Pod Video and Zuni MP3 players. Use caution whenever removing or handling plastic parts of any vehicle.
MAQICPLATE™ MOUNTING OPTION 1 NOTE: For mounting directly to device, use the large single plate with template guide as shown in the instructions below. © & Remove Line up the Harare Sows onion. per backing © Template Guide to fom both plates the to the bottom of your phone. REMOVING THE PLATE Uss a thin plastic card to carefully Sift the © plate's adhesive surface from the mounting surface. Slowly ft up and remove the plate.
MAQICPLATE™ MOUNTING OPTION 3 (Continued) TUBE: For mounting dict? fo Galaxy S388, use the (@ small pales with the integrated template guide for Galaxy as shown. “For mounting directly to device only. Do not mount io case. & Remove the © Line up “U” white paper channel to the backing from fingerprint reader both plates. and camera on the phone. Remove the backing from the protective film as shown on the removal tabs (A), and place between the device and the lower plats (B).
codification Required: Please read complete instructions fore proceeding. Location modification required for this installation, proceed with caution. If you are unsure or feel that the installation is to difficult, we recommend you seek professional installation. Note that additional installation fees may apply and vary by location. Scorcher is not possible or liable for any additional fees or modification done by the installer.
pL (CRT Th Cont'd 4. Remove the two hidden hex screws securing the steering column's lower panel by doing the following steps 4A and 4B below, see accompanying illustrations for visual reference. 4A. Using a panel removal tool carefully remove the bottom rail panel on the driver's side door. Next, uncle the driver's left-side kick panel enough to expos the first hidden screw {screw 1 of 2, illustration 4A). 4B.
VEHICLE DISASSEMBLY Ley 150] 7. Using a panel removal tool remove @ the center panel surrounding the [ radio and disconnect any attached |i:wiring (illustration 7). 8. Remove the {4) screws securing ®) the radio in place, disconnect it and set aside for re-installation. uge a panel removal tool to remove the vent panels surrounding the radio dash cavity (illustration 9}. 10.
TESTING QI MODULE (MQ Testing Connection Before proceeding to the compartmentalization please test the modules functionality by connecting the provided vehicle specific t harness {diagram on right). Once the modules is connected, place the Q-enabled device on the module and refer to the LED Status chart below for specifics.
TATTOO ASSEMBLY 1. Route the type-c USB connector @® under and through the hole created during the preparation step on page 6 (see illustration A). 2. Second, route the same connector through the designated slot on the Qi bezel (B), then place the bezel into it’s pocket location {C). 3. Third, make the necessary 12V B connections to power the device if you have not already done so, then carefully tuck/hide away any excess wiring (refer to Testing Connection and the diagram provided). 4.
This equipment has been tested and found to comply with the limits for a WPC device, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the product.