Owner's Manual

VEHICLE ASSEMBLY
5. Connect the provided power t-harness
according to the diagram displayed in
the Test Connection box at the top of
page 5 or illustrated at the right.
Connect the female and male 12V
power connectors first then route the
type-c connector to the designated
slot created during the preparation
step at the bottom of page 5.
©----------,
6. With the power connected to the
t-harness, route the type-c connector
under the shifter panel through the hole
created in the preparation step on page
5, and lastly through the TAQ03 Qi
bezel.
Note: Tuck away any excess cable
under this panel, away from the
shifter.
7. Use the provided two-sided adhesives
to secure the panel/module from
moving then connect the Qi module to
the type-c connector. Once the
module is connected place it into the
bezel then reconnect everything in
reverse order of the disassembly to
complete the installation.
~ Female connector to
"""' vehicle 12V harness connector
L To Qi Module ~
~
~~= d11 ~ p , CJ:J
~ 1
1
(MQUSM) .,,.
...6 Male connector to
"""" back of 12V socket
©-------~ ~--------,
Lastly, place your Qi
enabled device onto
the TAQ03 assembly
to charge your device.
Refer to LED Charging
Status for charging A
~" - ~-~
----- :---" /¼#':
6
I
'
Cr._1