Owner's Manual

VEHICLE ASSEMBLY
7. Connect the provided power
t-harness according to the diagram
displayed under the Test Connection
at the top of page 6 or see illustration
on the right. Connect the female and
male 12V power connectors first then
route the type-c connector to the
designated slot created during the
preparation steps on page 6.
Fema le Connector to
1 2V harness connector
.~ ~ /<aCJ] ♦
♦~ . To Qi Module
M ale Connector to (M QUSM)
Back of 12V Socke t
8. Routing the type-c connector through I':\. c==~====--=----_-..;. ___ -:l
the pocket/Qi-bezel: ~---=~"' ~~~ ..
A. Pass the Type-C connector
through the hole created durring
preparation on the pocket.
B. Second, pass the connector
through the TAQ04 bezel.
C. Place direct-Qi bezel into the
pocket location.
9. Routing the type-c connector to the
MQUSM Qi module: @.----- ... .-.-.. -lfllll111191111!11111
A. Connect the Type-C connector to
the MQUSM.
B. Place the module onto Qi bezel
C. Re-install the pocket into place
using screws removed durring
disassembly.
Notes:
• Hide any excess wiring under the panels /
pocket before reassembling .
• Use the provided two - sided adhesives to
secure the panel / module from moving .
10. Lastly, reassemble everything in
reverse order, then place your Qi
enabled device onto the TAQ04
assembly to charge your device.
Refer to LED Charging Status for
charging details (page 5).
*Phone NOT Included
7