Owner's Manual
REMOVING THE METAL PLATE
Use a thin plastic card
to
carefully lift the plate's adhesive surface from the mounting
surface. Slowly lift up and remove the plate.
Do
not
use
any
heat
or
liquids
to
remove
the
plate,
due
to
risk
of
damaging
your
phone.
Contact
Scosche
Customer
Service
for
any
additional
assistance
at
800.363.4490
Ext. 1
or
customerservice@scosche.com
UNIVERSAL FLUSH MOUNT,
PLACEMENT
IN
VEHICLES
It is possible .for the transmitter
to
in
te
rf
ere with some wireless systems
within a car. Specifically key fobs with
immobilizer, key-less start systems
or
tire pressure monitors.
Th
erefore,
it
is
recommended
to
test the location
of
your
transmitter before deciding on a
fin
al
placement. Most interference
issues will be minimized by considering
the following placement guidelines:
• I
nstall
tr
ansmitte
r a
minimum
of 1 0 '
inches away from the ignition lock,
key fob docking station,
or
any
location where the key fob might be
stored while driving.
When
placing
the
Qi-enabled
device
on
the
charger
please
take
note
that
the
magnets
are
located
on
the
side
where
stated
MAGIC
MOUNT
LEO
indicator
on
the
side
of
the
mount
illuminates
(See
LED
Charging
..__
___
__,
Status
below
for
details).
If
the transmitter cannot be located a sufficient distance away as described above
please use the following suggestions whenever possible:
• Insert the key
fob
into the docking slot whenever possible while transmitting the
transmitter.
• Connect the transmitter
to
a 12 volt accessory port that is powered only while the
vehicle's ignition is
in
the "ACC" or "ON" position.
• Place phone on the transmitter after the vehicle is started.
LED
Charging
Status:
The L
ED
indicator on the side
of
the mount
illuminates the
ch
arging status
of
the device. When powered ON, the indicator blinks
in
the following order BLUE, GREEN, BLUE.
Standby
= Green
Charging
=
Blue
3