Owner's Manual
ASSEMBLY
INSTRUCTIONS
Test
Connection
Before proceeding
to
the installation please test the modules functionality by
connecting the provided universal
power
connector, refer to
the
wiring diagram
below
(C). Once the module is connected, place the Qi-enabled device on the
module and refer
to
the LED Status chart on the bottom
of
page 3 for specific
details on the LED lighting. For technical assistance with the installation please call or
visit
us
on the web
at:
1-800-363-4490
x11
www.scosche.com/contact
Modification
Required
Proceed
with
CAUTION!
Use
the
Illus
t
ration
for
demonstration
use
only.
Vehicle
disassembly/
modification
may
vary
per
installation/vehicle.
e
-1
1. Type-.c
to
01
b&zel
2. T-hamess female connection
to
vehicle
12v
power
connector
3. T-harness
male connection
to
back
of
1
2v
socket
I
nstallation
Instructions
1 . Select a mounting location
(A).
2.
Route the provided power harness
to
the nearest 12V
power
(B).
3.
Disassemble panels
to
gain access
to
the selected 12V connector.
4.
Test the modules functionality
by
connecting the provided t-harness
to
the power
source and the
type-c
connector
to
the module
(C),
wiring diagram.
5.
Custom-make a slot
for
the bezel
to
settle in and create a hole large enough to
pass the type-c connector through,
if
necessary
(D).
6.
Reassemble everything in reverse order
of
your disassembly to complete the
installation
and
place
the
Qi-enabled
device
on
the
charging
surface
(E).
4