MSDS

3M MATERIAL SAFETY DATA SHEET 3M Brand Caulk Remover, Catalog No. 2153 11/20/2006
_________________________________________________________________________________________________
Page 4 of 7
Ingredient Authority Type Limit Additional Information
CYANIDES OSHA TWA, as CN 5 mg/m3 Skin Notation*; Table Z-1
DIMETHYL ADIPATE CMRG TWA, as Dimethyl
Esters
1.5 ppm
DIMETHYL GLUTARATE CMRG TWA, as Dimethyl
Esters
1.5 ppm
* Substance(s) refer to the potential contribution to the overall exposure by the cutaneous route including mucous membrane and eye,
either by airborne or, more particularly, by direct contact with the substance. Vehicles can alter skin absorption.
SOURCE OF EXPOSURE LIMIT DATA:
ACGIH: American Conference of Governmental Industrial Hygienists
CMRG: Chemical Manufacturer Recommended Guideline
OSHA: Occupational Safety and Health Administration
AIHA: American Industrial Hygiene Association Workplace Environmental Exposure Level (WEEL)
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Odor, Color, Grade:
off white, slight ester odor.
General Physical Form:
Liquid
Autoignition temperature
No Data Available
Flash Point
>=225 ºF [Test Method: Closed Cup]
Flammable Limits - LEL
No Data Available
Flammable Limits - UEL
No Data Available
Boiling point
>=100 ºC
Vapor Density
No Data Available
Vapor Pressure
Approximately 8 mmHg [Details: CONDITIONS: 77 degrees F]
Specific Gravity
1.00 - 1.03 [Ref Std: WATER=1]
pH
Approximately 7 Units not avail. or not appl.
Melting point
No Data Available
Solubility In Water
No Data Available
Evaporation rate
<=0.01 [Ref Std: WATER=1]
Volatile Organic Compounds
Approximately 214 g/l [Test Method: South Cost Air Qual Mgmt
Dist]
Percent volatile
94 - 97 % weight
VOC Less H2O & Exempt Solvents
No Data Available
Viscosity
60000.0 - 110000.0 centipoise
SECTION 10: STABILITY AND REACTIVITY
Stability: Stable.
Materials and Conditions to Avoid: Strong acids; Strong bases; Strong oxidizing agents
Hazardous Polymerization: Hazardous polymerization will not occur.