SDS

Scotchgard™ Fabric Water Shield 4106-PF 05/05/23
__________________________________________________________________________________________
Page 4 of 10
Water may not effectively extinguish fire; however, it should be used to keep fire-exposed containers and surfaces cool and
prevent explosive rupture.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Evacuate area. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use only non-sparking tools.
Ventilate the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or
exhaust vapors, in accordance with good industrial hygiene practice. Warning! A motor could be an ignition source and
could cause flammable gases or vapors in the spill area to burn or explode. Refer to other sections of this SDS for
information regarding physical and health hazards, respiratory protection, ventilation, and personal protective equipment.
6.2. Environmental precautions
Avoid release to the environment.
6.3. Methods and material for containment and cleaning up
If possible, seal leaking container. Place leaking containers in a well-ventilated area, preferably an operating exhaust hood, or
if necessary outdoors on an impermeable surface until appropriate packaging for the leaking container or its contents is
available. Contain spill. Cover spill area with a fire-extinguishing foam. Working from around the edges of the spill
inward, cover with bentonite, vermiculite, or commercially available inorganic absorbent material. Mix in sufficient
absorbent until it appears dry. Remember, adding an absorbent material does not remove a physical, health, or
environmental hazard. Collect as much of the spilled material as possible using non-sparking tools. Place in a metal
container approved for transportation by appropriate authorities. Clean up residue with an appropriate solvent selected by
a qualified and authorized person. Ventilate the area with fresh air. Read and follow safety precautions on the solvent label
and SDS. Seal the container. Dispose of collected material as soon as possible in accordance with applicable
local/regional/national/international regulations.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Do not use in a confined area with minimal air exchange. Keep out of reach of children. Keep away from heat/sparks/open
flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Do not pierce or burn, even
after use. Do not breathe dust/fume/gas/mist/vapors/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink
or smoke when using this product. Wash thoroughly after handling. Avoid contact with oxidizing agents (eg. chlorine,
chromic acid etc.)
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Store
away from heat. Store away from acids. Store away from oxidizing agents.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Occupational exposure limits
No occupational exposure limit values exist for any of the components listed in Section 3 of this SDS.
8.2. Exposure controls
8.2.1. Engineering controls
Do not remain in area where available oxygen may be reduced. Use general dilution ventilation and/or local exhaust
ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapors/spray.
If ventilation is not adequate, use respiratory protection equipment.