User's Manual

Kit Number: KBT44

use with ID200, ID250 and C0330, C0530, C0630, C0830, C1030, CME256, CME506,

CME656, CME806, CME1056

Includes:

Description Qty.

Cover, Gray 1

Lid Assembly 1

Bracket 2

#8 Screw 6

RTV 1

Label, Disconnect Power Before Cleaning 1

Acorn Nut, 8—32 Nylon 2

Sealing Washer 2

Baffle, Ice 1

#8 Nylon Washer 2

Insulation Strip 1

1. Unpack kit.

2. Place insulation strip (item 12) over studs on the baffle and insert baffle assembly into

the adapter lid.

3. Place (2) sealing washers (item 9) over studs and (2) flat washers (item 11), then

fasten in place with (2) plastic acorn nuts (item 8).

4. Set ice maker lid on the top of the dispenser.

5. Using the slotted holes in the lid as a template, drill four (4) .140 in. diameter (9/64

in.) holes at the bottom of the slots (see detail A). Use extreme care not to drill into the

hopper. Fasten the lid to the dispenser with four (4) #8 sheet metal screws, two on each

side.

6. Seal the ice maker to the top of the dispenser as follows:

A. Run beads of RTV around the opening in the lid and inside of the perimeter of the ice

maker outline so that the ice maker will set on the RTV.

B. Set the ice maker onto the lid and position it as required.

C. Wipe away the excess RTV.

Instructions

620201018

PAGE 1
Instructions Kit Number: KBT44 use with ID200, ID250 and C0330, C0530, C0630, C0830, C1030, CME256, CME506, CME656, CME806, CME1056 Includes: Description Cover, Gray Lid Assembly Bracket #8 Screw RTV Label, Disconnect Power Before Cleaning Acorn Nut, 8—32 Nylon Sealing Washer Baffle, Ice #8 Nylon Washer Insulation Strip Qty. 1 1 2 6 1 1 2 2 1 2 1 1. Unpack kit. 2. Place insulation strip (item 12) over studs on the baffle and insert baffle assembly into the adapter lid. 3.
PAGE 2
7. Drill 9/64”diameter holes into the ice maker cabinet using the bracket as a template. Use extreme care not to drill into any ice maker components (condenser, tubing, etc.). Secure the brackets using the screws provided. 8. Follow the ice maker manual’s instructions to complete the installation of the ice maker.
PAGE 3
9. If the plastic acorn nuts interfere with the positioning of the plastic manual fill cover, it may be necessary to make small notches in the back of the cover to clear the acorn nuts.