Owner's Manual

REPAIR
Curtain
The curtain keeps the water that sprayed by the
pump from falling in the bin.
The “sheet” type curtain is replaced by:
1. Removing 4 screws holding the curtain and the
curtain stiffener to reservoir.
2. Pulling the curtain and curtain stiffener out of the
machine.
3. Replace with a new curtain and install as shown.
Inlet Water Valve
The inlet water valve may need to be cleaned or
replaced. If there is not enough water coming into
the machine, the valve may need to be cleaned. If
the valve does not work at all, or does not shut off
tightly, it should be replaced.
1. Unplug or disconnect electrical power.
2. Shut off water supply
3. Remove kickplate
4. Remove the control box cover.
5. Unscrew flare nut from inlet water valve inlet . If
the valve is being replaced, proceed to step 10.
6. Unscrew brass fitting from body of inlet water
valve.
Check the screen of the valve, it may be clogged
and is restricting the flow of water into the
machine. If that is the problem, clean the screen
and reverse the steps so far to reassemble.
7. Loosen the screws in the back of the control
box, and remove the inlet water valve.
8. Remove the discharge hose from the outlet of
the water valve.
9. Unplug the wire harness from the top of the
valve.
10. Replace with a new valve, and reverse the
above steps to reassemble.
DCE33
September 2011
Page 23
Electrical Shock Hazard
Disconnect Electrical
Power Before Beginning
Removal of Parts
Inlet Water Valve
Inlet
Screen
Outlet
SERVICE OF THE INLET
WATER VALVE
Curtain
Screw
Curtain
Sheet
Type:
Curtain
Stiffener
Bottom Edge
Angle to Rear
Front Edge of
Reservoir
Curtain and Curtain Stiffener MUST Be Installed
As Shown