User's Manual

11. Route wire thru 2 loop clamps, wrap once around each clamp: one about 2 - 3"
from switch and the other 8 – 10” up from switch.
12. Route switch wire up right edge of freezing compartment, over back wall next to ice
thickness sensor wire, to the left part of the cabinet.
13. Remove cover from wire chase and route wire into back of controller box. Be sure
wire is routed away from ice making area.
14. Disconnect existing curtain switch and connect the new one in its place. Leave
original switch wire loose in control box.
15. Remove slack from wires. Secure loop clamps to side of freezing compartment
using provided screws.
A
Loop Clamps
Wire Routing
Switch and
Bracket Detail,
locate bracket
against right
inside corner of
compartment
Switch and
Bracket
Wire Routing