Installation Instructions

ManualsBrandsScotsman ManualsCubersScotsman EH330 Prodigy Plus Eclipse 1400

Installation Instructions for

Prodigy Eclipse Condensing Unit

models ECC0800, ECC1200, ECC1410, ECC1800

17-3456-01

992.81

39.09

814.22

32.06

32.05

1.26

TYP.

TOP VIEW

1009.65

39.75

FRONT VIEW

83.67

3.29

74.12

2.92

163.02

6.42

248.87

9.80

491.69

19.36

63.50

2.50

887.73

34.95

750.06

29.53

330.86

13.03

SIDE VIEW

LINE SET AND ELECTRICAL ATTACHMENT SIDE

1/2" COOL VAPOR LINE

3/8" LIQUID LINE

3/4" SUCTION LINE

.88" ELECTRICAL INLET

INTERFACE HARNESS

ACCESS HOLE

Summary of content (4 pages)

PAGE 1
Installation Instructions for Prodigy Eclipse Condensing Unit models ECC0800, ECC1200, ECC1410, ECC1800 TOP VIEW 992.81 39.09 814.22 32.06 SIDE VIEW LINE SET AND ELECTRICAL ATTACHMENT SIDE FRONT VIEW 32.05 1.26 TYP. 330.86 13.03 750.06 29.53 887.73 34.95 .88" ELECTRICAL INLET 1009.65 39.75 3/4" SUCTION LINE 1/2" COOL VAPOR LINE 3/8" LIQUID LINE 83.67 3.29 63.50 2.50 74.12 2.92 INTERFACE HARNESS ACCESS HOLE 163.02 6.42 248.87 9.80 491.69 19.
PAGE 2
Introduction A remote low side cuber system consists of two systems: an ice making section and a remote condensing unit. This instruction manual covers the Condensing Unit. Unpack 1. Remove the carton. 2. Disconnect condensing unit from skid 3. Remove both side panels. 4. Locate and retain communication wire. Placement The footprint of the condensing unit is 39” x 32”. Have roof equipment rails prepared for it. Plan on attaching the unit per local building codes, including any hurricane requirements.
PAGE 3
Model Voltage ECC0800-32 ECC0800-3 ECC1200-32 ECC1410-3 ECC1410-32 ECC1800-3 208-230/60/1 208-230/60/3 208-230/60/1 208-230/60/3 208-230/60/1 208-230/60/3 Minimum Circuit Ampacity 14.8 10.6 17.8 9.1 14.5 19.0 Maximum Fuse Size System Charge Cabinet Size wxdxh 20 15 20 15 20 20 192 192 224 224 224 232 32 x 39 x 39.75 32 x 39 x 39.75 32 x 39 x 39.75 32 x 39 x 39.75 32 x 39 x 39.75 32 x 39 x 39.75 Connect electrical power to the wires in the junction box on the side of the unit.
PAGE 4
Connect Refrigeration Requires brazing, steps must be performed by an EPA certified type II or higher technician. At Head: 1. Remove protective plugs from all three connections and vent the nitrogen from the ice machine. 2. Route the each of the three tubes to its connection. 3. Remove the top panel and attach a refrigeration hose with depressor to the 1/2” vapor line access valve so the valve is OPEN. This is a vent for nitrogen purging. 4.