Installation manual

What to do before calling for service
Normal Operation
Ice
The machine will make either flaked or nugget ice,
depending upon the model. The ice will be
produced continuously until the bin is full.
Heat
Most heat is exhausted at the remote condensing
unit or at the rack; the ice machine should not
generate significant heat.
Noise
The ice machine will make noise when it is in ice
making mode. The gear reducer will produce
sound. Some ice making noise could also occur.
These noises are all normal for this machine.
Reasons the machine might shut itself off:
•
Lack of water.
• Does not make ice
•
Auger motor overloaded
•
Controller self test failure.
Check the following:
1. Has the water supply to the ice machine or
building been shut off? If yes, the ice machine will
automatically restart within minutes after water
begins to flow to it.
2. Has power been shut off to the ice machine? If
yes, the ice machine will automatically restart when
power is restored.
3. Has someone shut the power off to the remote
condensing unit while the ice machine still had
power? If yes, the ice machine may need to be
manually reset.
To Manually Reset the machine.
• Push and release the Off button.
• Push and release the On button.
To Shut the Machine Off:
1. Push and hold the Off button for 3 seconds or
until the machine stops.
July 2009
Page 16
N0622L, F0822L, N0922L, F1222L, N1322L, F1522L
Remote Low Side User's Manual
Indicator Lights & Their Meanings
Light Actions Power Status Water
De-Scale &
Sanitize
Steady Green Normal Normal - -
Blinking Green Self Test Failure
Switching on or off.
When Smart-Board
used, machine attention
recommended.
--
Blinking Red - Diagnostic shut down Lack of water -
Yellow - - -
Time to descale
and sanitize
Blinking Yellow - - - In Cleaning Mode
Light Off No power Switched to Off Normal Normal
All Blinking Unit is remotely locked out - check with leasing company