Installation manual

Location:
While the machine will operate satisfactorily within
the air and water temperature limits, it will operate
more efficiently when those temperatures are
nearer the lower limits. Avoid locations that are hot,
dusty, greasy or confined.
Options
The standard machine will make ice until ice fills
the bin and blocks an infrared light beam inside the
bottom of the machine. A field installed kit is
available to adjust the ice level lower. That kit
number is KVS.
The standard controller has excellent diagnostic
capabilities and communicates to the user through
the AutoAlert light panel, seen through the front
panel. There is a field installed kit that can log data
and provide additional information when the front
panel is removed. That kit number is KSBU. A
similar kit adds network connectivity, and its
number is KSB-NU.
Bin compatibility
All models are the same width: 22 inches. All
models are the same depth: 24 inches.
Bin & adapter list:
•
B222S – no adapter needed
•
B322S – no adapter needed
•
B330P – Use KBT27
•
B530P – Use KBT27
•
B530S – Use KBT27
•
B842S – Use KBT39
•
B948S - Use KBT38 for a single unit
•
B948S – Use KBT38-2X for two units side by
side
BH1100, BH1300 and BH1600 upright bins include
filler panels to accommodate a 22 inch wide ice
machine. No adapter is needed.
Dispenser compatibility
Only nugget ice models may be used with ice
dispensers. Flaked ice is not dispensable.
•
ID150 – use KBT42 and KDIL-PN-150;
includes KVS, KNUGDIV and R629088514
•
ID200 – use KBT43 and KNUGDIV and KVS
•
ID250 – use KBT43 and KNUGDIV and KVS
See sales literature for other brand model ice and
beverage dispenser applications.
Other Bins & Applications:
Note the drop zone and ultrasonic sensor locations
in the illustrations on the next page.
Line Set
NRTE45 is a non-precharged tubing kit that
contains a 45 foot 3/8" liquid line and a 45 foot 5/8"
suction line. Tubes are supplied nitrogen charged
and capped.
Scotsman ice systems are designed and
manufactured with the highest regard for safety
and performance.
Scotsman assumes no liability of responsibility of
any kind for products manufactured by Scotsman
that have been altered in any way, including the
use of any part and/or other components not
specifically approved by Scotsman.
Scotsman reserves the right to make design
changes and/or improvements at any time.
Specifications and design are subject to change
without notice.
July 2009
Page 3
N0622L, F0822L, N0922L, F1222L, N1322L, F1522L
Remote Low Side User's Manual