Service Manual
Table Of Contents
- Specifications
- Cabinet Layout
- Air flow
- Water Quality
- Door Covering
- Door Panel Attachment
- Custom Panel
- Door swing change
- Installation: Water & Drain
- Gravity Drain
- Electrical
- Cube Size Adjustment
- Harvest Time Adjustment
- Control Settings
- Use
- How to clean the condenser and winterize
- How to remove scale from the ice making system
- System Information
- Water System
- Components
- Controller
- Performance Information
- Refrigeration System
- Thermistor Values
- Service Diagnosis
- Service Diagnosis
- Removal and Repair
- Removal and Repair
- Removal and Repair - Cabinet Removal
- Refrigeration Service
SCCG50 & SCCP50
Service Manual
June 2008
Page 31
16. Remove two screws holding freezing
compartment brace to cabinet, lift brace up.
17. Lift evaporator platen up and tilt back enough
for bin assembly to clear the base.
18. Remove air bafe.
19. Unplug 7 wire harness connector (at back of
bin).
20. Remove 1 screw at each corner of the base.
21. Lift bin assembly off the base.
Note: Prop evaporator assembly up. A 3' length of
3/4" PVC tubing with one end inserted into the cup
mold and the other against the base will hold it up.
The hot gas valve, fan motor, condenser and
compressor are now exposed for service.
Brace
Air Bafe
Chassis Shown in Front of Bin Assembly