Installation and User's Manual for Residential Ice Machine Models SCCG50 and SCCP50
SCCG50 & SCCP50 Installation and User's Manual Introduction: This ice machine is the result of Scotsman’s decades of experience as an industry leader in the design and manufacture of both commercial and residential ice machines. This manual includes the information needed to install, start up and maintain the ice machine. Note any Caution or Warning indicators, as they provide notice of potential hazards. Keep this manual for future reference. Table of Contents Specifications . . . . . . . . . . . . . . .
SCCG50 & SCCP50 Installation and User's Manual Specifications This ice machine is designed to be used indoors, in a controlled environment. It can be used in a wide variety of environmental conditions, but there are limits. Use outside of the listed limitations is misuse and will void the warranty. Air temperature limits: The ice machine will operate adequately within the limits, but functions best in temperatures between 70 and 80 degrees F. • Minimum – 50 degrees F. (10oC) • Maximum – 100 degrees F.
SCCG50 & SCCP50 Installation and User's Manual Cabinet Layout FLOOR DRAIN ACCESS HOLE 3 7/8" 20 3/8" 22" .75 SHEET METAL DOOR FRONT .63 MIN. CABINET DOOR 14 7/8" 29 1/4" 33 3/8" MIN. 34 3/8" MAX. DRAIN FLEXIBLE TUBING 3/8 I.D. PUMP MODEL (INCLUDED) 5/8 I.D.
SCCG50 & SCCP50 Installation and User's Manual Air flow The machine takes in room temperature air at the lower right front and forces warm air out the lower left front. Restricting the airflow will adversely affect the ability of the ice machine to make ice. Model and Serial Number Tag Warm Air Out Air Intake Scotsman Ice Systems are designed and manufactured with the highest regard for safety and performance. They meet or exceed the standards of agencies like U.L.
SCCG50 & SCCP50 Installation and User's Manual Water Quality All water, including potable water supplied by municipalities, contains some impurities or minerals. Water absorbs impurities from the air as rain and/or as it flows through the ground. Some of the impurities are solid particles, these are known as suspended solids, and a fine particle filter will remove them. Other impurities are chemically bonded to the water molecules, and cannot be filtered out, these are called dissolved solids.
SCCG50 & SCCP50 Installation and User's Manual Door Covering Door Panel Custom Panel The ice machine is supplied without a conventional door covering so it can be decorated to the user’s preference. Scotsman offers several coverings including white, black and stainless steel. In addition, a custom built panel can be placed onto the door. A custom panel of wood or other material not exceeding 15 lb can be attached to the door. Attachment is from the ice side of the door.
SCCG50 & SCCP50 Installation and User's Manual Door Panel Attachment Use Upper Hole at the Top Scotsman Door Panel Gasket Machine Screw Hole Plug Use Lower Hole at the Bottom Cover June 2008 Page 7
SCCG50 & SCCP50 Installation and User's Manual Door swing change The door can be attached to open with hinges on the left or right using new hinge brackets shipped loose in the ice bin. Retain all screws for re-use. 8. Replace the bracket with the one supplied loose with the machine. Secure it using the original screws. To change: 9. Remove the upper hinge and move it to the door's opposite side, bottom location. Secure using the original screws. 1.
SCCG50 & SCCP50 Installation and User's Manual Installation: Water & Drain 3. Install a compression fitting on the tubing and The recommended water supply tubing is ¼ inch connect to the inlet of the solenoid. OD copper. Stainless steel flex or reinforced PCV tube may also be used. Install an easily accessible shut-off valve between the supply and the unit. This Drains shut-off valve should not be installed behind the unit.
SCCG50 & SCCP50 Installation and User's Manual Gravity Drain Caution: Restrictions in the drain system to the machine will cause water to back up into the ice storage bin and melt the ice. Gravity drain tubing must be vented, have no kinks and slope to the building drain. Air gaps are typically required by local code. 1. Place the ice machine in front of the installation opening. Adjust leveling legs to the approximate height. 2. Remove the front service access panel and the upper back panel.
SCCG50 & SCCP50 Installation and User's Manual Electrical The ice machine is supplied with a power cord. Do not remove the grounding pin from the cord’s plug. Do not use extension cords. Follow all codes. Connect the machine to its own 115 volt, 15 amp circuit. 1. If the electrical outlet for the ice maker is behind the unit, plug in the unit. 1. Has the unit been connected to the proper water supply? 2. Has the water supply been checked for leaks? 3. Has the unit been connected to a drain? 4.
SCCG50 & SCCP50 Installation and User's Manual Use No special instructions are needed for use. Just take as much ice as you need, the machine will replace it. A scoop is provided, and it can be stored in the machine using the loop of tubing on the right side as a holder. That tubing is also the ice level sensor; ice will fill the storage bin until it's near to or on that tube and then the machine will shut off. The machine can be shut off anytime by just pushing and releasing the On/Off button.
SCCG50 & SCCP50 Installation and User's Manual How to clean the condenser and winterize. Condenser cleaning Winterizing The condenser is like the radiator on a car, it has fins and tubes that can become clogged with dirt and lint. To clean: 1. Clean the ice making system. 2. Open the door and push and release the On/Off switch to turn the machine off. 1. Remove the kickplate and front service panel. 3. Turn off the water supply. 2. Locate the condenser surface. 4.
SCCG50 & SCCP50 Installation and User's Manual How to remove scale from the ice making system. 1. Scoop out all of the ice, either discard it or save it in an ice chest or cooler. 2. Press and HOLD the On/Off button in for 3 seconds until the Green light goes out. 10. Clean the bin liner of mineral scale by mixing some ice machine scale remover and hot water, and using that solution to scrub the scale off of the liner. 11. Rinse the liner with hot water. 12. Sanitize the bin interior. 13.
SCOTSMAN ICE SYSTEMS 775 Corporate Woods Parkway, Vernon Hills, IL 60061 800-533-6006 www.scotsman-ice.
