Service Manual
Table Of Contents
- Specifications
- Cabinet Layout
- Air flow
- Water Quality
- Door Covering
- Door Panel Attachment
- Custom Panel
- Door swing change
- Installation: Water & Drain
- Gravity Drain
- Electrical
- Cube Size Adjustment
- Harvest Time Adjustment
- Control Settings
- Use
- How to clean the condenser and winterize
- How to remove scale from the ice making system
- System Information
- Water System
- Components
- Controller
- Performance Information
- Refrigeration System
- Thermistor Values
- Service Diagnosis
- Service Diagnosis
- Removal and Repair
- Removal and Repair
- Removal and Repair - Cabinet Removal
- Refrigeration Service
SCCG50 & SCCP50
Service Manual
June 2018
Page 17
How to clean the condenser and winterize
Condenser cleaning
The condenser is like the radiator on a car, it has
ns and tubes that can become clogged with dirt
and lint. To clean:
1. Remove the kickplate and front service panel.
2. Locate the condenser surface.
3. Vacuum the surface, removing all dust and lint.
Caution: Do not dent the ns.
4. Return the kickplate and front service panel to
their original positions. Fasten them to the cabinet
using the original screws.
Winterizing
1. Clean the ice making system.
2. Open the door and push and release the
On/Off switch to turn the machine off.
3. Turn off the water supply.
4. Drain the water reservoir by removing the
rubber cap under the reservoir or black drain pulg
it’s near the back wall of the ice storage bin.
5. Disconnect the incoming water line at the inlet
water valve.
6. Open the door, push and release the on/off
switch to turn the machine on.
7. Blow air through the inlet water valve; a tire
pump could do the job.
8. Drain pump models should have about
1/2 gallon of RV antifreeze (propylene glycol)
poured into the ice storage bin drain.
Note: Automotive antifreeze must NOT be used.
9. Switch off and unplug the machine.