Service Manual
Table Of Contents
- Specifications
- Cabinet Layout
- Air flow
- Water Quality
- Door Covering
- Door Panel Attachment
- Custom Panel
- Door swing change
- Installation: Water & Drain
- Gravity Drain
- Electrical
- Cube Size Adjustment
- Harvest Time Adjustment
- Control Settings
- Use
- How to clean the condenser and winterize
- How to remove scale from the ice making system
- System Information
- Water System
- Components
- Controller
- Performance Information
- Refrigeration System
- Thermistor Values
- Service Diagnosis
- Service Diagnosis
- Removal and Repair
- Removal and Repair
- Removal and Repair - Cabinet Removal
- Refrigeration Service
SCCG50 & SCCP50
Service Manual
June 2008
Page 30
Removal and Repair - Cabinet Removal
Certain components require the removal of the
cabinet for repair access.
1. If the machine is in a freeze mode, perform a
manual harvest.
2. Remove all ice.
3. Drain reservoir.
4. Remove service panel and kick plate.
5. Remove back panel.
6. Disconnect electrical power.
Electrical Shock
Hazard.
Disconnect electrical
power before
beginning removal
7. Disconnect water and drain tubing.
8. Remove door.
9. Remove top panel.
10. Remove controller box cover.
11. Disconnect thermistor from controller, pull wire
back to suction line.
12. Remove curtain & hanger.
13. Locate elbows where water ows onto the
evaporator platen.
14. Pull clip up. Push inner elbow back and rotate it
until it points straight up, then push it back through
the hole in the back of the freezing compartment.
15. Pull water inlet elbow out of inner elbow.
Thermistor
Connector
Inlet
Elbow
Clip
Inner
Elbow
Inlet
Elbow