Service Manual

SCCG50 & SCCP50
Service Manual
June 2008
Page 8
Custom Panel
A custom panel of wood or other material not
exceeding 15 lb can be attached to the door.
Attachment is from the ice side of the door. Holes
are provided in the door for this purpose.
To create and attach a custom panel:
• Panel width: 14 7/8”
• Panel height: Between 29 3/8” and 30 3/8”.
• Panel thickness: 5/8” to ¾”
1. Measure overall height of cabinet
opening where ice machine will be
(oor to bottom of countertop edge).
2. Determine desired kickplate
space (from bottom of door to oor).
This could be equal to the adjacent
cabinet’s kickplate space or another
space the user wants.
3. Subtract kickplate space from
cabinet opening.
4. Subtract 1/8 or more for clearance
space between top of door and
bottom of countertop edge from
cabinet opening. This is the
maximum door length.
5. Cut panel to width.
6. Cut panel to length (cabinet space
- kickplate space - top clearance =
length).
7. Determine top of panel.
8. Mark hole locations using drawing
on the back of these instructions.
Drawing assumes top of panel will be
ush with top of door. Measure hole
locations from the top of the panel.
9. Drill pilot holes for wood screws.
Use drill stop to prevent drilling
through the panel.
10. Mount panel to door using wood screws or
supplied panel mounting screws.
Note: When installed Ice machine must be
adjusted for height to position top of door to
desired clearance.
Ø8/1"
TYP. (10)
16/13"
32/13"
8/1 4"
32/25 6"
16/11 14"
64/31 13"
32/13"
4/1 8"
16/9 13"
8/7 14"
8/3 30
"
8/3 29
"
{Centerline}