Product Manual

FLOAT PLATFORM
PUMP ASSEMBLY
NYLON ANCHORING LINE
STAINLESS STEEL FILTER BASKET
SELF-TAPPING SCREWS
STAINLESS STEEL
BOLTS
This Kit Includes
1 - FLOAT PLATFORM
1 - MOTOR ASSEMBLY
1 - STAINLESS STEEL WIRE BASKET
3 - SELF TAPPING SCREWS
Tools Needed
ONE 3/8" WRENCH OR
SOCKET SCREWDRIVER
TWO 1/2" WRENCHES (OR PLIERS)
Boilermaker
Assembly Instructions
1.Removethetwostainless-steelboltsfromtheoat.
2. PlaceyourBoilermakeronend,propellersidefacingup.SliptheoatovertheBoilermakeruptotheattachedeyebolts.
Usethepre-drilledholestofastentheoattotheBoilermaker,usingthetwostainless-steelbolts.
3.Now,turnyourBoilermakeroverandplaceonitsoppositeend.Securethestainless-steellterbaskettothe
Boilermakerbyaligningthethreeltereyeletstothethreepre-drilledholesontheBoilermakerandsecuringwith
the enclosed stainless-steel screws.
4. Next, secure a nylon anchoring line (not provided) to each of the two attached eyebolts.
5.Atthispoint,yourBoilermakercanbeoatedintopositioninyourpondorlake.Onceasuitablelocationis
determined, simply attach a boat anchor, concrete block, or similar weighted item to each of the two attached
nylon lines. Once attached, simply place the two anchors at the bottom of the pond spaced a minimum twenty
feet apart.
6.ThenalstepistosupplyelectricpowertoyourBoilermaker,takingextracautiontoalwaysuseagroundfault
circuit interrupter and a licensed electrical contractor.
!
Do NOT use an extension cord
to supply power to the motor
Always use a GFCI
Always disconnect the power
when swimmers are present
!